User Manual

Application Note #480
15 Technical Support — 800.523.9466
®
Advanced Programming Mode (continued)
Programming Option 5: Nightlight Mode
What it Does
When the Maestro® Sensor Dimmer is turned OFF and the light goes out, the ILs remain ON in a dim glow state, known as
Nightlight mode. Disabling Nightlight mode is an energy-saving practice and also allows the dimmer to be compatible with
a broader range of CFLs and LEDs. Enabling Nightlight mode provides a soft glow for easy location of the dimmer in a dark
room.
Settings
Enable Nightlight Mode: ILs will glow when Maestro® Sensor Dimmer is OFF.
Disable Nightlight Mode: ILs will stay OFF when Nightlight Mode is OFF.
Default Setting
Nightlight Mode Enabled
Directions
1. Enter Enable/Disable Nightlight Mode Menu: While
in APM, press the or button to select the fifth
option, Programming Option 5: Enable/Disable Nightlight
Mode. Once IL 5 is blinking, press the
T
button.
2. Select Enable/Disable Nightlight: Once in the menu, IL4
will begin blinking rapidly. This indicates that Nightlight
Mode is Enabled. Tapping the button will cause the IL
to stop blinking. No ILs blinking indicates that Nightlight
Mode is Disabled. To enable Nightlight Mode, tap the
button so that IL 4 resumes rapid blinking.
3. Press the
T
button one time to set the Enable/Disable
Nightlight Mode and return to the APM main menu.
Notes:
– It may be necessary to disable the ILs (Nightlight
mode) when using certain CFL and LED bulbs to
achieve best bulb performance.
– If there is no button activity for 1 minute, the dimmer will automatically exit APM and return to Normal Operation.
Continued on next page…
IL 4: Indicator Light is ON (fast-blinking)
Enable/Disable Nightlight Mode
Or
T
FASSTM
To Exit any mode or programming step:
– Press and hold the
T
button for 5 seconds
or
– Pull the FASSTM out, then push the FASSTM back in
or
– Wait for 1 minute