User Manual

2
Application Note #480
www.lutron.com
®
Glossary
Auto-ON . . . . . . . . . . . . . . . Setting to adjust how the dimmer responds to initial occupancy of the room.
Auto-ON: ALD . . . . . . . . . . Setting in which the dimmer turns ON upon initial occupancy of the room only if there is not
enough ambient light. Based on the user’s interactions with the
T
button, the Maestro®
Sensor Dimmer will learn the user’s preference for when it should turn ON once motion is
detected. (Also called Ambient Light Detect mode.)
Auto-ON: Disabled . . . . . . Setting where the dimmer will turn ON only when the
T
button is pressed, but will still turn
OFF automatically when the room is vacated. (Also called Vacancy mode.)
Auto-ON: Enabled . . . . . . . Default setting for the Maestro® Sensor Dimmer. The sensor automatically turns ON upon initial
occupancy of the room, and turns OFF when the room is vacated. (Also called Occupancy
mode.)
Auto-ON: OWO . . . . . . . . . Setting in which the lights remain OFF even as the room continues to be occupied. (Also called
OFF‑While‑Occupied mode.)
Default Setting . . . . . . . . . Original preset options to which the dimmer is programmed before initial use.
FASSTM . . . . . . . . . . . . . . . . Front Accessable Service Switch is the tab at bottom of Maestro® Sensor Dimmer, required to
be pulled out before replacing light bulb(s) and entering all programming modes. (Also called Air
Gap.)
High-End Trim . . . . . . . . . . An adjustable feature that allows the user to set the brightest achievable light level in the
dimmer.
Indicator Lights (ILs) . . . . . LEDs on dimmer that show current light level and are also used to indicate programming
status.
Low-End Trim . . . . . . . . . . Dimmest stable light level to which the dimmer can be adjusted.
Load . . . . . . . . . . . . . . . . . . The light bulb(s) that the dimmer is controlling.
Locked Preset . . . . . . . . . . A programmable light level to which the dimmer will illuminate with a single press of the
T
button.
Occupied Level . . . . . . . . . A programmable light level to which the dimmer will illuminate once occupancy has been
detected.
Occupied Level: 100% . . . The default set point for occupied level in which the Maestro® Sensor Dimmer turns ON all
lights to 100% of the dimmable light level.
Occupied Level: 50% . . . . The setting in which the Maestro® Sensor Dimmer turns ON all lights to 50% of their dimmable
light level.
Occupied Level: Preset. . . Setting in which the Maestro® Sensor Dimmer achieves a customized light level when the
T
button is pressed.
Sensitivity. . . . . . . . . . . . . . Setting to adjust the level of motion needed to trigger the Maestro® Sensor Dimmer.
Sensor LED . . . . . . . . . . . . LED that glows when motion is detected; positioned next to Maestro® Sensor Dimmer lens.
Test Mode . . . . . . . . . . . . . A temporary, short timeout (less than 15 seconds) that can be used to test the Maestro®
Sensor Dimmer coverage while in the Programming Mode.
Timeout . . . . . . . . . . . . . . . Setting that determines how long the lights will remain ON after motion is no longer detected.
Unlocked Preset . . . . . . . . Setting in which a single press of the
T
button turns the dimmer ON to the last light level.