User Manual

20
Application Note #480
www.lutron.com
®
Two-Location Applications Using an Existing Switch (continued)
Selecting Two-Location Application Shortcut
Default Setting
Companion Dimmer (IL 4)
Directions
This feature is accessible only through the shortcut and cannot be entered via the APM menu.
1. Enter 3-way Programming Menu: Press and hold
the
T
button and the button until an IL blinks.
2. Select Desired Device: Press the or button
to select an option:
– IL 1: Mechanical Switch
– IL 4: Companion Dimmer
3. Press the
T
button one time to set the option and
return to the APM main menu.
Notes:
– Rewiring of existing switch is required; consult your
instruction sheet for installation procedures.
– If switch is not rewired, it may result in abnormal
behavior; consult the instruction sheet for wiring
procedure.
– If the existing mechanical switch was rewired but the
Maestro® Sensor Dimmer was not reprogrammed to accommodate this switch, perform steps 1 and 2 above, and select
Mechanical Switch (IL 1).
IL 4 (Default)
IL 1
T
FASSTM
To Exit any mode or programming step:
– Press and hold the
T
button for 5 seconds
or
– Pull the FASSTM out, then push the FASSTM back in
or
– Wait for 1 minute