User Manual

Application Note #480
7 Technical Support — 800.523.9466
®
Programming Mode
Enter Programming mode to change the settings on your Maestro® Sensor Dimmer.
Note: Once a feature is modified, the setting is immediately saved.
Enter Programming Mode
(see picture at right)
1. Pull the FASSTM toward you into the OFF position.
2. Press and hold the
T
button of the product you are
programming.
3. Push the FASSTM away from you into the ON
position while continuing to hold the
T
button for
approximately 5seconds until IL 1 blinks quickly.
4. Continue programming: Go to Main Sensor Menu
section below.
Note: If there is no activity for 1 minute, the Maestro®
Sensor Dimmer will exit Programming mode
automatically.
Main Sensor Menu
1. Press the or button to position the glowing IL
next to the feature you want to modify:
IL #7 ..... Advanced Programming Mode
IL #4 ..... Occupied Level
IL #3 ..... Auto-ON (occupancy version only)
IL #2 ..... Sensitivity
IL #1 ..... Timeout
2. Press the
T
button one time to select that feature.
3. Go to the appropriate selection menu, starting below, to
continue programming.
Selection Menu: Timeout
Once you've selected Timeout from the Main Sensor
Menu, proceed with the following steps.
In the Timeout Menu
1. Press the or button to move the blinking IL to
desired Timeout duration.
2. Press the
T
button one time to set the Timeout
duration and return to the Main Sensor Menu.
Default Setting: 5 minutes.
IL 7: Advanced Programming Mode
IL 4: Occupied Level
IL 3: Auto-ON
IL 2: Sensitivity
IL 1: Timeout
Main Sensor Menu
IL 7: Test Mode *
IL 5: 30 minutes
IL 4: 15 minutes
IL 3: 5 minutes (Default)
IL 2: 3 minutes
IL 1: 1 minute
Selection Menu: Timeout
* Test Mode is a temporary, short timeout (less than 15-seconds) that can
be used to test the Maestro® Sensor Dimmer coverage. After entering Test
Mode, the device will exit Test Mode automatically after 5 minutes, or when
any button is pressed. If no motion is detected, the lights will turn OFF. If
motion is detected, the lights will turn ON and continue to stay ON for as
long as motion is detected. The sensor LED will flash when motion has been
detected.
Continued on next page…
FASSTM
ILs
Programming Mode
T
7
6
5
4
3
2
1
To Exit any mode or programming step:
– Press and hold the
T
button for 5 seconds
or
– Pull the FASSTM out, then push the FASSTM back in
or
– Wait for 1 minute