User Manual

8
Application Note #480
www.lutron.com
®
Programming Mode (continued)
Selection Menu: Sensitivity
Once you’ve selected Sensitivity from the Main Sensor Menu, proceed with the following steps.
In the Sensitivity Menu
1. Press the or button to move the blinking IL to
desired sensitivity.
2. Press the
T
button one time to set the Sensitivity level
and return to the Main Sensor Menu.
Default Setting: High sensitivity.
Selection Menu: Auto-ON
(Occupancy Version, MSCL-OP153M, Only)
Once you’ve selected Auto‑ON from the Main Sensor
Menu, proceed with the following steps.
In the Auto-ON Menu
1. Press the or button to move the blinking IL to
desired Auto‑ON setting.
2. Press the
T
button one time to set the Auto‑ON
setting and return to the Main Sensor Menu.
Default Setting: Auto‑ON Enabled.
Selection Menu: Occupied Level
Once you’ve selected Occupied Level from the Main
Sensor Menu, proceed with the following steps.
In the Occupied Level Menu
1. Press the or button to move the blinking IL to
desired Occupied Level.
2. Press the
T
button one time to set the Occupied Level
and return to the Main Sensor Menu.
Default Setting: 100%.
IL 4: OFF-While-Occupied
IL 3: Ambient Light Detect
IL 2: Disabled
IL 1: Enabled (Default)
Selection Menu: Auto-ON
IL 7: 100% (Default)
IL 4: 50%
IL 1: Preset
Selection Menu: Occupied Level
IL 2: High (Default)
IL 1: Low
Selection Menu: Sensitivity
T
FASSTM
To Exit any mode or programming step:
– Press and hold the
T
button for 5 seconds
or
– Pull the FASSTM out, then push the FASSTM back in
or
– Wait for 1 minute