User Manual
Table Of Contents
- Maestro Occupancy/ Vacancy Sensor C•L Dimmer Models
- Overview
- Glossary
- Maestro Sensor Dimmer Coverage Area
- Maestro Sensor Dimmer Features in Programming Mode
- Dimming Features in Advanced Programming Mode
- Programming Mode
- Advanced Programming Mode
- Restoring Default Settings
- Two-Location Applications Using an Existing Switch
- Ambient Light Detection (ALD)
- Troubleshooting
- Maestro Sensor Dimmer Bulb Compatibility
- Lutron Contact Numbers
Application Note #480
9 Technical Support — 800.523.9466
®
Advanced Programming Mode
Enter Advanced Programming Mode (APM)
1. While in Main Sensor menu, press the or button
until IL 7 is blinking.
2. Press the
T
button one time to enter the APM menu.
Selection Menu: Advanced Programming
Mode
1. While in APM menu, press the or button to
position the slowly blinking IL next to the feature you
want to modify.
2. Press the
T
button one time to select that feature for
modification.
3. Go to the appropriate section starting on page 10 to
continue programming.
Note:
– If there is no button activity for 1 minute, the dimmer
will automatically exit APM and return to Normal
Operation.
Continued on next page…
Or
IL 7: High-End Trim
IL 6: Low-End Trim
IL 5: Nightlight Mode
IL 4: Delayed Fade to OFF Time
IL 3: Manual Fad OFF Time
IL 2: Manual Fad ON Time
IL 1: Preset Light Level
Selection Menu:
Advanced Programming Mode
IL 7: Advanced Programming Mode
IL 4: Occupied Level
IL 3: Auto-ON
IL 2: Sensitivity
IL 1: Timeout
Main Sensor Menu
T
FASSTM
To Exit any mode or programming step:
– Press and hold the
T
button for 5 seconds
or
– Pull the FASSTM out, then push the FASSTM back in
or
– Wait for 1 minute