Installation Guide

2
To remove, break fins along scores using pliers.
Remove inner side sections
only (shaded).
Do not remove outer side
sections.
Operation
Push button in the center of slider to turn lights on to level set by
the slider. Raise slider to increase light level and lower slider to
decrease light level. Push button again to turn lights off. In 3-way
applications when switching from a remote location, lights turn
on to level set by dimmer's slider. See below.
Lamp Aging
To ensure proper dimming performance and full lamp life,
fluorescent lamps must be operated at full in ten si ty for 100
hours prior to dimming.
Minimum Light Level Adjustment
This unit is factory calibrated and does not normally require
low-end light level adjustment. If lamps flicker or drop out at
the minimum dimming level, there may be an installation error.
Continued use of the system in this mode will cause premature
lamp failure. If this is occurring, call the Lutron Technical
Support Center at: 1-800-523-9466. Please provide exact
model number when calling.
Push
On/Off
Adjust
Light
Level
ON
OFF
ON
OFF
ON
OFF
7. Attach slider and snap wallplate on.
8. Turn power ON at circuit breaker or replace fuse.
Multigang Installation
Multiple dimmers can be installed in a common gangable
wallbox or a series of interconnected wallboxes for a clean,
consolidated appearance. Multigang wallplates are available
for such installations. Refer to instruction sheet supplied with
multigang wallplates for installation.
For new installations, dimmers can be ganged without removing
side sections. However, to reduce the size of multigang
installations or to fit existing wallboxes, inner side sections must
be removed (see below).