Installation Manual

Mounting Instructions
1. Push wires into wallbox, allowing room for control to
be inserted. Do not pinch wires between wallbox
and control.
2. Mount control to wallbox using screws provided.
Controls must be mounted vertically. See stamp on
control for correct positioning.
3. Mount adapter plate with mounting screws provided
(see below).
4. Snap on slider and faceplate.
Control
Control
Mounting
Screws
Adapter
Mounting
Screws
Faceplate Adapter
Slider
Faceplate
Operation
Slide-to-Off Controls
Raise slider to increase light intensity. Lower slider to
decrease light intensity and turn off.
Preset Controls
Push button in center of slider to turn lights on to preset
level (set by slider) and to turn lights off. Raise slider to
increase light intensity. Lower slider to decrease light
intensity.
3-Way and 4-Way Controls
When switching power from remote location, lights will
turn on to level set on control (by slider), or turn off.
Raise slider to increase light intensity. Lower slider to
decrease light intensity and turn off.
Fluorescent Controls
Controls are factory calibrated and do not require low-
end light adjustment. If lamps flicker or drop out at the
minimum dimming level there may be an installation
error. Continued use of the system in this mode will
cause premature lamp failure. If this is occurring, call
the Lutron Technical Assistance Hotline at: 1-800-
523-9466.
To ensure proper dimming performance and full lamp
life, fluorescent lamps must be operated at full intensity
for 100 hours prior to dimming.