Cut Sheet

2
|
Lutron® 24/7 Technical Support—800.523.9466
product specifications
01.21.11
369-225f
RadioRA 2 Maestro® Local Controls
Specifications
Model Numbers Dimmer: RRD-6D-XX, RRD-10D-XX, RRD-10ND-XX, RRD-6NA-XX,
RRD-F6AN-DV-XX
Switch: RRD-8ANS-XX, RRD-8S-DV-XX
Remote: RD-RD-XX, RD-RS-XX, RD-RD-277-XX, RD-RS-277-XX
Power 120 V 50 / 60 Hz (-6D, -10D, -10ND, -6NA, -8ANS, -RD, -RS)
120 – 277 V
50 / 60 Hz (-F6AN-DV, -8S-DV)
277 V
50 / 60 Hz (-RD-277, -RS-277)
Typical Power
Consumption
Dimmer / Switch: 0.2 W
Test conditions: load is off and nightlight mode is enabled.
Remote Dimmer / Switch: 0 W
Test conditions: load is off.
Regulatory Approvals UL, CSA (all except -6NA), cUL (-6NA only), NOM, FCC, IC, COFETEL
Environment Ambient operating temperature: 32 °F to 104 °F (0 °C to 40 °C),
0% to 90% humidity, non-condensing. Indoor use only.
Communications Dimmers and switches communicate with the system through Radio
Frequency (RF) and must be located within 30 ft (9 m) of a repeater.
Remote dimmers / switches are not required to be within a specific
range of a repeater. System devices operate on frequencies between
431.0 MHz and 437.0 MHz.
ESD Protection Tested to withstand electrostatic discharge without damage or memory
loss, in accordance with IEC 61000-4-2.
Surge Protection Tested to withstand surge voltages without damage or loss of operation,
in accordance with IEEE C62.41-1991 Recommended Practice on
Surge Voltages in Low-Voltage AC Power Circuits.
Power Failure Power failure memory: should power be interrupted, the control will
return to its previous state when power is restored.
Mounting Requires a U.S. wallbox. 3 ½ in (89 mm) deep recommended, 2 ¼ in
(57 mm) deep minimum.
Wiring Uses conventional 3-way and 4-way wiring.
Warranty 1 Year Limited Warranty. http://www.lutron.com/resiinfo
Dimmer
•
On a single-tap, lights fade ON or OFF.
•
On a double-tap, lights go to full ON.
•
When ON, press and hold the tapswitch to
engage the delayed long fade to OFF.
•
Light levels can be fine-tuned by pressing and
holding the dimming rocker until the desired
light level is reached.
•
Neutral and two-wire dimmers available.
Design Features
Switch
•
On a single-tap, lights or motors turn ON or OFF.
•
Neutral and two-wire switches available.