Information Sheet

product specifications 369227f 02.19.14
5 Technical Support: 800.523.9466 (USA)
+44.(0)20.7702.0657 (Europe)
www.lutron.com
Qualified Level 2 (L2)
dealers/installers can
upgrade their software
to provide support for
a 200 device system
by enabling the
addition of a second
main repeater subnet
to the system.
Note: To learn how
you can become a
qualified L2 dealer/
installer, please
contact your local
Lutron® representative.
RadioRA® 2 Repeaters
Using Two Main Repeaters for Qualified Dealers/Installers Only
Main repeater subnet #2Main repeater subnet #1
Main
Main
Auxiliary
Dimmer
Keypad
Ethernet
1
Router/HUB/Switch
2
Auxiliary
Dimmer
Keypad
Setup
Wired
RF
Communication
Repeater Status
1
3
4 2
M
Main Repeater
Power
Repeater Link
COM
9 V
1
N / C
MUX
MUX
2
3
4
AddTest
Integrate Program / Integrate
RS232
Ethernet
Setup
Wired
RF
Communication
Repeater Status
1
3
4 2
M
Auxiliary Repeater
Power
Repeater Link
COM
9 V
1
N / C
MUX
MUX
2
3
4
AddTest
Setup
Wired
RF
Communication
Repeater Status
1
3
4 2
M
Auxiliary Repeater
Power
Repeater Link
COM
9 V
1
N / C
MUX
MUX
2
3
4
AddTest
Optional
3
RS485
Setup
Wired
RF
Communication
Repeater Status
1
3
4 2
M
Main Repeater
Power
Repeater Link
COM
9 V
1
N / C
MUX
MUX
2
3
4
AddTest
Integrate Program / Integrate
RS232
Ethernet
PC
1
The two main repeaters must be connected by Ethernet during and
after PC programming. The two main repeaters do not communicate
over the RF link.
2
The two main repeaters may be connected over Ethernet by
one of the following:
a. Router
b. HUB or switch (only if static IP addresses are being used)
c. After PC programming is complete, direct Ethernet connection
without a router, HUB, or switch (only if static IP addresses are
being used)
3
Auxiliary repeaters and main repeaters on the same subnet can
be optionally connected by RS485 wired links when the repeater
RF range is exceeded.
a. The RS485 wired link cannot be connected between the
two main repeater subnets
b. The RS485 wired link cannot be connected between
two main repeaters.
c. RS485 wired links can be used between any combination
of main and auxiliary repeaters on the same subnet.