Installation Manual

106
Lutron integration protocol
seeTouch Keypad (continued)
DEVICE Commands (continued)
DEVICE Command-specific fields (continued)
Action Numbers and Parameters:
Action Action Number Parameters
Set (#) Press or CCI Close 3 None
Set (#) Release or CCI Open 4 None
Set (#) Hold 5 None
Set (#) Multi-tap 6 None
Set (#) or Get (?) LED State
1,2
9 0 = Off
1 = On
2 = Normal-Flash: 1 flash every second
1
3 = Rapid-Flash: 10 flashes every second
1
NOTES
1. Available only on units in a Quantum, HomeWorks, or myRoom plus system.
2. Quantum, HomeWorks, or myRoom only. “Set” is for unprogrammed buttons and buttons with LED logic
‘Defined by Integration.’
Example DEVICE Commands
Examples presume keypad has been assigned Integration ID 2.
Operation Command String
Execute: #DEVICE, Integration ID, Component Number, Action Number, Parameters
Press Button 1. #DEVICE,2,1,3<CR><LF>
Turn On LED 5. #DEVICE,2,85,9,1<CR><LF>
Query: ?DEVICE, Integration ID, Component Number, Action Number
What is the state of LED 1? ?DEVICE,2,81,9<CR><LF>
Response: ~DEVICE, Integration ID, Component Number, Action Number, Parameters
LED 1 is On. ~DEVICE,2,81,9,1<CR><LF>