Installation Manual

20
Lutron integration protocol
INTEGRATION ID Command Formats
INTEGRATION ID Command-specific fields
Action Numbers and Parameters:
Description Action Number Parameters
Set (#) or Get (?) Integration ID for
a Serial Number
1
Serial Number = 8 character HEX serial number of the device
Integration ID = The integration ID to be assigned.
Set (#) Change Integration ID 2 Current Integration ID, New Integration ID
Note: An error will be reported if the new Integration ID is the
same as an existing Integration ID in the system.
Get (?) Info from ID 3 Integration ID
Note: If this field is left blank, all integration IDs will be printed.
Set (#) or Get (?) Output
Integration ID
4 Serial Number, Component Number, Integration ID
Example INTEGRATION ID Commands
Operation Command String
Execute: #INTEGRATIONID, Action Number, Parameters
Set the Integration ID for a serial number #INTEGRATIONID,1,1234ABCD,kitchen dimmer<CR><LF>
Response: ~INTEGRATIONID, Action Number, Parameters
Set the Integration ID for a serial number ~INTEGRATIONID,1,1234ABCD,kitchen dimmer<CR><LF>
Execute: ?INTEGRATIONID, Action Number, Parameters
Get the Integration ID for a serial number ?INTEGRATIONID,1,5678EFEF<CR><LF>
Response: ~INTEGRATIONID, Action Number, Parameters
Get the Integration ID for a serial number ~INTEGRATIONID,1,5678EFEF,living room keypad<CR><LF>
Execute: #INTEGRATIONID, Action Number, Parameters
Change the Integration ID #INTEGRATIONID,2,diningroomlights1,diningroomaccents<CR><LF>
Response: ~INTEGRATIONID, Action Number, Parameters
Change the Integration ID ~INTEGRATIONID,2,diningroomlights1,diningroomaccents<CR><LF>
Execute: ?INTEGRATIONID, Action Number, Parameters
Get information about an Integration ID
command
?INTEGRATIONID,3,livingroomkeypad<CR><LF>
Response: ~INTEGRATIONID, Action Number, Parameters
Get information about an Integration ID command ~INTEGRATIONID,3,livingroomkeypad,DEVICE,5678EFEF<CR><LF>
QS Standalone (continued)
System Commands (continued)
INTEGRATION ID Commands
Use “INTEGRATIONID Command-specific fields” tables
to complete these command fields.
Operation
Command
#INTEGRATIONID, Action Number, Parameters