Installation Manual

26
Lutron integration protocol
QS Standalone (continued)
System Commands (continued)
DEVICE Commands
DEVICE Command Formats
DEVICE Command-specific fields
Action Numbers and Parameters:
Description Action Number Parameters
Set (#) activate the phantom button preset 3 None
Set (#) a custom level of the shades, lighting zones
programmed to the phantom button
1
14 Level: The level the shades will go to
1
Set (#) Start Raising Shades
2
18 None
Set (#) Start Lowering Shades
2
19 None
Set (#) Stop Raising or Lowering Shades 20 None
Set (#) a custom lift and tilt level of venetian blinds pro-
grammed to the phantom button
1
23 Lift level %
Tilt level %
Set (#) a custom lift level only of venetian blinds pro-
grammed to the phantom button
1
24 Lift level %
Set (#) a custom tilt level only of venetian blinds pro-
grammed to the phantom button
1
25 Tilt level %
NOTES
1. Specifying a custom level above will not affect the preset level programmed for the phantom button.
2. For Venetian blinds, the Raise & Lower Actions will affect either the lift or the tilt based on how the phantom button was
programmed. If #PROGRAMMING Action 5 is used (affecting both lift and tilt levels), then the Raise & Lower Actions will
affect the tilt.
Example DEVICE Commands
The following examples show how we can activate phantom buttons on a link with a
QSE-CI-NWK-E whose Integration ID is “1.”
Operation Command String
Activate Preset on phantom button 1 #DEVICE,1,1,3<CR> <LF>
Set the level of all shades programmed to phantom button 2 to 50% #DEVICE,1,2,14,50<CR><LF>
Set all venetian blinds programmed to phantom button 3 to a lift level of
50% and tilt level of 25%
#DEVICE,1,3,23,50,25<CR><LF>
Set all venetian blinds programmed to phantom button 4 to a lift level of 50% #DEVICE,1,4,24,50<CR><LF>
Set all venetian blinds programmed to phantom button 5 to a tilt level of 25% #DEVICE,1,5,25,25<CR><LF>
Raise the shades and venetian blinds programmed to phantom button 6 #DEVICE,1,6,18<CR><LF>
Lower shades and venetian blinds programmed to phantom button 7 #DEVICE,1,7,19<CR><LF>
Stop shades and venetian blinds programmed to phantom button 8 #DEVICE,1,8,20<CR><LF>
Operation
Command
Integration ID or Serial # of
the QSE-CI-NWK being used
Use “DEVICE Command-specific fields” tables
to complete these command fields.
Phantom Button Number
(can be 1–100)
#DEVICE, 1, Button Number, Action Number, Parameters