Installation Manual

PGM
10
Lutron® integration protocol
DEVICE Command Format
DEVICE Command-specific fields
Component Number:
Component Component Number Available Actions
Button 1–100 2-101 Press
LED 1–100 102-201 Set (#) or Get (?) LED state
NOTE: Set is for LEDs
on unprogrammed buttons only
Action Numbers and Parameters:
Action Action Number Parameters
Press 3 None
Set (#) or Get (?) LED
State
* Set not allowed for
programmed LEDs
9 0=Off
1=On
Example DEVICE Messages
Examples presume programming control interface has been assigned Integration ID 4.
Operation Command String
Execute: #DEVICE, Integration ID, Component Number, Action Number, Parameter
Press Button 1. #DEVICE,4,2,3<CR><LF>
Turn on LED 1. #DEVICE,4,102,9,1<CR><LF>
Response: ~DEVICE, Integration ID, Component Number, Action Number, Parameters
LED 1 is on. ~DEVICE,4,102,9,1<CR><LF>
Use “DEVICE Command-specific fields” tables
to complete these command fields.
Operation
Command
Integration ID (example)
#DEVICE, 4, Component Number, Action Number, Parameters
SZ-CI-PRG: DEVICE Commands
Stanza
® System Commands