Installation Manual
Table Of Contents
- Table of Contents
- About Integration
- Stanza
- QS Standalone
- RadioRA 2
- Quantum
- HomeWorks QS
- Devices
- Stanza Keypads
- Tabletop Stanza Keypads
- Stanza Dimmers
- Stanza Switch
- Stanza Lamp Module
- Stanza Input/Output Interface
- GRAFIK Eye QS
- Energi Savr Node QS/DALI
- Energi Savr Node QS/Int'l 0-10V
- Energi Savr Node QS/EcoSystem
- Energi Savr Node QS/0-10V
- seeTouch QS Keypads
- seeTouch QS Int'l Keypads
- Sivoia QS Shades
- Sivoia QS Venetian Blinds
- Maestro Dimmers
- Hybrid Keypad
- Tabletop seeTouch Keypads
- Pico Wireless Controls
- Visor Control Receiver
- Radio Powr Savr
- HVAC Controller
- Wireless Temperature Sensor
- Dynamic Keypad
- Programmers Appendix
- Contact Information
114
Lutron® integration protocol
Tabletop seeTouch® Keypads:
DEVICE Commands
DEVICE Command Formats
Use “DEVICE Command-specific fields” tables
to complete these command fields.
Operation
Command
Integration ID (example)
#DEVICE, 3, Component Number, Action Number, Parameters
•
Component Number: (continued)
Component Component Number Available Actions
LED 1 81 Set or Get LED state
LED 2 82 Set or Get LED state
LED 3 83 Set or Get LED state
LED 4 84 Set or Get LED state
LED 5 85 Set or Get LED state
LED 6 86 Set or Get LED state
LED 7 87 Set or Get LED state
LED 8 88 Set or Get LED state
LED 9 89 Set or Get LED state
LED 10 90 Set or Get LED state
LED 11 91 Set or Get LED state
LED 12 92 Set or Get LED state
LED 13 93 Set or Get LED state
LED 14 94 Set or Get LED state
LED 15 95 Set or Get LED state