Installation Manual

20
Lutron® integration protocol
PROGRAMMING Command Formats
PROGRAMMING Command-specific fields
•
Programming Type:
Description Action # Parameters
Add programming to a
phantom button
(Shade level only)
1
a) Shade Integration ID – The Integration ID of the
shade being programmed
b) Shade Component # – Always ‘0’
c) Level – The level to which the shade being
programmed will go to on activation of this
button
Clear programming from a
phantom button.
NOTE: Use button #0 to clear
programming from all buttons.
3 None
Configure Stop-If-Moving
functionality
NOTE: Use button #0 to configure Stop-
If-Moving functionality on all buttons.
4 0 = Stop-If-Moving OFF
1 = Stop-If-Moving ON
Add programming to a phantom
button
(Venetian blind, lift & tilt levels)
5 a) Venetian Integration ID
b) Component Number (always 0)
c) Lift level
d) Tilt level
Add programming to a phantom
button
(Venetian blind, tilt only)
6 a) Venetian Integration ID
b) Component Number (always 0)
c) Tilt level
Add programming to a phantom
button
(Venetian blind, lift only)
7 a) Venetian Integration ID
b) Component Number (always 0)
c) Lift level
Integration ID or Serial # of
the QSE-CI-NWK being used
See table
below
Operation
Phantom Button #
(can be 1-100)
Command
#PROGRAMMING, 1, Button#, Action#, Parameters
QSE-CI-NWK-E: PROGRAMMING Commands
Con/Act
FD/Col
DATA RX
DATA TX
RS232 RX
RS232 TX
LNK/ACT
PWR
1 2 3 4
1 2 3 4 5 6 7 8
QSE-CI-NWK-E
24 V 100 mA
800.523.9466
1.610.282.3800
www.lutron.com/qs
QS Link
QS Standalone System Commands (continued)