Installation Manual
Table Of Contents
- Table of Contents
- About Integration
- Stanza
- QS Standalone
- RadioRA 2
- Quantum
- HomeWorks QS
- Devices
- Stanza Keypads
- Tabletop Stanza Keypads
- Stanza Dimmers
- Stanza Switch
- Stanza Lamp Module
- Stanza Input/Output Interface
- GRAFIK Eye QS
- Energi Savr Node QS/DALI
- Energi Savr Node QS/Int'l 0-10V
- Energi Savr Node QS/EcoSystem
- Energi Savr Node QS/0-10V
- seeTouch QS Keypads
- seeTouch QS Int'l Keypads
- Sivoia QS Shades
- Sivoia QS Venetian Blinds
- Maestro Dimmers
- Hybrid Keypad
- Tabletop seeTouch Keypads
- Pico Wireless Controls
- Visor Control Receiver
- Radio Powr Savr
- HVAC Controller
- Wireless Temperature Sensor
- Dynamic Keypad
- Programmers Appendix
- Contact Information
26
Lutron® integration protocol
Setup
Wired
RF
Communication
Repeater Status
1
3
4
2
M
Main Repeater
Power
Repeater Link
COM
9 V
1
N / C
MUX
MUX
2
3
4
AddTest
Integrate
Program / Integrate
RS232
Ethernet
USB
Why Integrate with the RadioRA® 2 Main Repeater?
•
Integrates a RadioRA 2 lighting control system with a PC or other digital equipment that supports
RS232 or Ethernet TCP/IP communication.
•
Allows monitoring and control of system devices. For example, the Main Repeater can be used to
simulate button presses, report button presses, monitor LEDs, and control light levels of dimmers.
Integration Capabilities
•
100 “virtual” programmable buttons with LEDs (use DEVICE command)
•
Monitoring of changes to other system devices (use MONITORING command)
Additional Commands
•
MONITORING commands are used to program what types of messages the system will report
RadioRA® 2 Integration Access Points
Main Repeater
Model: RR-MAIN-REP-WH