Installation Manual

38
Lutron® integration protocol
AREA Command Formats
Use “AREA Command-specific fields” tables to
complete these command fields.
Operation
Command
#AREA
1, 2
, 2, Action Number, Parameters
Integration ID (example)
AREA Command-specific fields
Action Numbers and Parameters:
Action Action Number Parameters
Set (#) Area Level 1 Level
3
= 0–100 or 0.00–100.00,
Fade
4
in SS.ss
5
, SS, MM:SS, or HH:MM:SS
5
Delay
4
in SS.ss
5
, SS, MM:SS, or HH:MM:SS
5
Raise
6
2 None
Lower
6
3 None
Stop Raise/Lower 4 None
Set or Get Current
Scene
6 Scene Number
7
= 0-32
Set or Get Daylighting
Mode
7 1 = Active
2 = Inactive
Get Occupancy State 8 3 = Occupied
4 = Unoccupied
Set or Get Occupancy
Mode
9 1 = Occupancy and Vacancy
8
2 = Vacancy
8
3 = Not Applicable
9
4 = Inactive
Example AREA Messages
Operation Command String
Execute: #AREA, Integration ID, Action Number, Parameters
Set area level to 75% (Fade = 4 sec, Delay = 2
sec)
#AREA,2,1,70,4,2<CR><LF>
Lower Area. #AREA,2,3<CR><LF>
Query: ?AREA, Integration ID, Action Number
Is the area occupied? ?AREA,2,8<CR><LF>
What is the current active scene? ?AREA,2,6<CR><LF>
Response: ~AREA, Integration ID, Action Number, Parameters
The area is currently occupied. ~AREA,2,8,3<CR><LF>
Area Scene 2 is currently active. ~AREA,2,6,2<CR><LF>
Quantum® System Commands (continued)
QSE-CI-NWK-E: AREA Commands
Con/Act
FD/Col
DATA RX
DATA TX
RS232 RX
RS232 TX
LNK/ACT
PWR
1 2 3 4
1 2 3 4 5 6 7 8
QSE-CI-NWK-E
24 V 100 mA
800.523.9466
1.610.282.3800
www.lutron.com/qs
QS Link