Installation Manual
Table Of Contents
- Table of Contents
- About Integration
- Stanza
- QS Standalone
- RadioRA 2
- Quantum
- HomeWorks QS
- Devices
- Stanza Keypads
- Tabletop Stanza Keypads
- Stanza Dimmers
- Stanza Switch
- Stanza Lamp Module
- Stanza Input/Output Interface
- GRAFIK Eye QS
- Energi Savr Node QS/DALI
- Energi Savr Node QS/Int'l 0-10V
- Energi Savr Node QS/EcoSystem
- Energi Savr Node QS/0-10V
- seeTouch QS Keypads
- seeTouch QS Int'l Keypads
- Sivoia QS Shades
- Sivoia QS Venetian Blinds
- Maestro Dimmers
- Hybrid Keypad
- Tabletop seeTouch Keypads
- Pico Wireless Controls
- Visor Control Receiver
- Radio Powr Savr
- HVAC Controller
- Wireless Temperature Sensor
- Dynamic Keypad
- Programmers Appendix
- Contact Information
59
Lutron® integration protocol
INTEGRATION ID Command Formats
INTEGRATION ID Command-specific fields
•
Actions
Description Action # Parameters
Get (?) Integration ID for a Serial
Number
1 Serial Number = 8 character HEX serial number of the
device, Integration ID = The integration ID to be assigned.
Get (?) Info from ID 3 Integration ID
NOTE: If this field is left blank, all integration IDs will be
printed.
Example INTEGRATION ID Commands
Operation Command String
Execute: ?INTEGRATIONID, Action Number, Parameters
Get the Integration ID for a serial number
?INTEGRATIONID,1,5678EFEF
<CR><LF>
Response: ~INTEGRATIONID, Action Number, Parameters
Get the Integration ID for a serial number
~INTEGRATIONID,1,5678EFEF,1
<CR><LF>
Execute: ?INTEGRATIONID, Action Number, Parameters
Get information about an Integration ID
command
?INTEGRATIONID,3,1
<CR><LF>
Response: ~INTEGRATIONID, Action Number, Parameters
Get information about an Integration ID
command
~INTEGRATIONID,3,1,DEVICE,5678EFEF
<CR><LF>
Use “INTEGRATIONID Command-specific fields”
tables to complete these command fields.
Operation
Command
#INTEGRATIONID, Action Number, Parameters
HQP6-2-120: INTEGRATION ID Commands
HomeWorks
® QS System Commands (continued)