Installation Manual
Table Of Contents
- Table of Contents
- About Integration
- Stanza
- QS Standalone
- RadioRA 2
- Quantum
- HomeWorks QS
- Devices
- Stanza Keypads
- Tabletop Stanza Keypads
- Stanza Dimmers
- Stanza Switch
- Stanza Lamp Module
- Stanza Input/Output Interface
- GRAFIK Eye QS
- Energi Savr Node QS/DALI
- Energi Savr Node QS/Int'l 0-10V
- Energi Savr Node QS/EcoSystem
- Energi Savr Node QS/0-10V
- seeTouch QS Keypads
- seeTouch QS Int'l Keypads
- Sivoia QS Shades
- Sivoia QS Venetian Blinds
- Maestro Dimmers
- Hybrid Keypad
- Tabletop seeTouch Keypads
- Pico Wireless Controls
- Visor Control Receiver
- Radio Powr Savr
- HVAC Controller
- Wireless Temperature Sensor
- Dynamic Keypad
- Programmers Appendix
- Contact Information
8
Lutron® integration protocol
Why Integrate with the Stanza Programming Control Interface?
•
Integrates a Stanza lighting control system with a PC or other digital equipment that supports
RS232 or Ethernet TCP/IP communication
•
Allows monitoring and control of system devices. For example, the SZ-CI-PRG can be used to
simulate button presses, report button presses, monitor LEDs, and control light levels of dimmers.
Integration Capabilities
•
100 phantom “virtual” programmable buttons with LEDs (use DEVICE command)
•
Monitoring of changes to other system devices (use MONITORING command)
Supported Command Types
•
DEVICE allows control and monitoring of device inputs such as button presses and releases
•
MONITORING commands are used to configure what types of messages the system will report
PGM
1234567
1234567
Programming Control Interface
Model: SZ-CI-PRG
Stanza® Integration Access Points