Installation Manual

8
OUTPUT Command-specific fields
 Action Numbers and Parameters:
Action Action Number Parameters
Set(#)orGet(?)ZoneLevel 1 0–100or
0 00–100 00
SS ss
1
,SS,MM:SS,orHH:MM:SS
Set(#)StartRaising 2 None
Set(#)StartLowering 3 None
Set(#)StopRaisingorLowering 4 None
Set(#)StartFlashing
2
5 SS ss
1
,SS,MM:SS,orHH:MM:SS
Set(#)PulseTime 6 SS ss
1
,SS,MM:SS,orHH:MM:SS
Set(#)orGet(?)tiltlevel
3,4
9 TiltLevel
5
=0–100
6
or0 00–100 00
5,6

Fade
1
in:SS ss
2
,SS,MM:SS,orHH:MM:SS
Delay
3
in:SS ss
2
,SS,MM:SS,orHH:MM:SS
Set(#)orGet(?)lift&tiltlevel
4
10 LiftLevel
5
=0–100or0 00 –100 00
5

TiltLevel
5
=0–100
f
or0 00–100 00
5,6
Fade
1
in:SS ss
2
,SS,MM:SS,orHH:MM:SS
Delay
3
in:SS ss
2
,SS,MM:SS,orHH:MM:SS
Set(#) StartRaisingTilt
4
11 None
Set(#) StartLoweringTilt
4
12 None
Set(#) StopRaisingorLoweringTilt
4
13 None
Set(#) StartRaisingLift
4
14 None
Set(#) StartLoweringLift
4
15 None
Set(#) StopRaisingorLoweringLift
4
16 None
Set(#)DMXColororLevelSettings
7,8
17 Color/levelindex:0–255/0 00–100 00
Set(#)MotorJogRaise
7,9
18 None
Set(#)MotorJogLower
7,9
19 None
Set(#)Motor4-StageJogRaise
7,9
20 None
Set(#)Motor4-StageJogLower
7,9
21 None
NOTES
1  Fractionsareroundeduptotheclosest1/4second
2  Tostopadimmerfromashing,sendittoavalidlevel(action1)
3  TheDelaytimeisoptional Whennotused,thesystemwilluseazero-seconddelay Theminimumdelaytimeis
0seconds Themaximumdelaytimeis4hours
4  NotsupportedinQuantum
5  Forswitchedoutputs,anynon-zerolevelresultsinonorclosed,0resultsinofforopen
6  50forHorizontalSheerBlinds
7  NotsupportedinRadioRA2
8  SupportedinQuantumversion2 2andhigher
9  SupportedinQuantumversion2 5andhigher
Lutronintegrationprotocol
OUTPUT Command Format
Use “OUTPUT Command-specific fields” tables
to complete these command fields.
Operation
Command
Integration ID (example)
#OUTPUT,6,ActionNumber,Parameters
Integrator’s Reference (continued)
OUTPUT: Command Summary
Outputsaredimmers,CCOs,orotherdevicesinasystemthathaveacontrollableoutput Allof
thesedeviceswillacceptlevelsfrom0%to100%and0 00%to100 00%withagivenfadeand
delaytime Thesesamecommandscanbemonitoredastheyoccurinthesystem