Installation Manual

12
Lutronintegrationprotocol
MONITORING Command-specific fields
 Monitoring Type:
Description Monitoring Type
Set(#)orGet(?)DiagnosticMonitoring 1
Set(#)orGet(?)EventMonitoring 2
Set(#)orGet(?)ButtonMonitoring
1
3
Set(#)orGet(?)LEDMonitoring
1,2
4
Set(#)orGet(?)ZoneMonitoring
1
5
Set(#)orGet(?)Occupancy
1
6
Set(#)orGet(?)PhotoSensorMonitoring 7
Set(#)orGet(?)Scene#
1
8
Set(#)orGet(?)SystemVariable 10
Set(#)orGet(?)ReplyState(ifdisabled,allmessagesFROMtheintegrationaccesspoint
willcease)
1,3
11
Set(#)orGet(?)PromptState(ifdisabled,thepromptwillnotbeprintedtotheterminal)
1,3
12
Set(#)orGet(?)OccupancyGroupMonitoring 13
Set(#)orGet(?)DeviceLockStateMonitoring 14
Set(#)orGet(?)SequenceMonitoring
2
16
Set(#)orGet(?)HVACMonitoring
1,2,4
17
Set(#)orGet(?)ModeMonitoring
1,2,4
18
Set(#)orGet(?)ShadeGroupMonitoring
1,5
23
Set(#)orGet(?)PartitionWall
5,6
24
Set(#)orGet(?)TemperatureSensorMonitoring
1,7
27
Set(#)orGet(?)StateofAllMonitoring(exceptReplyandPrompt) 255
NOTES
1  Thefollowingmonitoringtypesareenabledbydefault,foruser-leveltelnetlogin:3-Button,4-LED,5-Zone,6-Occupancy,
8-Scene,11-Reply,12-Prompt,17-HVAC,18-Mode,23-Shade
2  NotsupportedinQSStandalone
3  Thefollowingmonitoringtypesareenabledbydefault,foradmin-leveltelnetlogin:11-Reply,12-Prompt
4  NotcompatiblewithQuantum
5  NotsupportedinRadioRA2andHomeWorksQS
6  NotsupportedviaQSE-CI-NWK-EinQuantum
7  SupportedbyPalladiomThermostatonly
Action Numbers:
Action Action Number
Enable 1
Disable 2
MONITORING Command Formats
Use “MONITORING Command-specific fields” tables
to complete these command fields.
Operation
Command
#MONITORING,MonitoringType,ActionNumber
Integrator’s Reference (continued)
MONITORING: Command Summary
Monitoringallowstheusertocongurewhattypesofmessagesthesystemwillreport
Note to Integrator:The default values of these are set in the programming database and restored
whenever the integration port is logged in. The user can temporarily change those settings to hide
or show information as desired.