Installation Manual

ii
Lutron integration protocol
Updates new to this release of the Lutron Integration Protocol
Revision Update: Y
About Integration
• Added“IntegrationBestPractices”section                             3
Integrator’s Reference
• Addedtworowstothetableandaddedfootnotes9,10,and11                  6
• Updatedthe“Parameters”for“Action#3”andaddedfootnote7                 10
• Changed“VenetianTilt”to“DeviceLockStateMonitoring”andaddedfootnotes5,6,and7   12
Temperature Controls
• Updatedthe“Parameters”for“Action#3”andaddedfootnote10 Alsorearrangedthefootnotesin
numericalorderandmadefootnote7intoageneralnote                     142
• Rearrangedthefootnotesinnumericalorderandmadefootnote6intoageneralnote     143
Palladiom Thermostat
• Updatedthe“DEVICECommandFormat”                             147
Wireless Temperature Sensor
• ChangestheParametervalueunder“ActionnumbersandParameters,”removedtheothertwo
rowsunder“ActionnumbersandParameters”aswellasthecorrespondingfootnotes      149
Customer Assistance
• AddedEuropeandAsiacontactnumbers                           157
Revisions to previous releases of the Lutron Integration Protocol
Revision Update: X
Global Changes
• Changed“multi-tap”to“double-tap”
• Addedafootnotetoeverypagewhere“Set(#)CurrentTemperature”ismentioned
Table of Contents
• Correctedpagenumbers
Integrator’s Reference
• Addedarowfor“PhotoSensorMonitoring”and“OccupancyGroupMonitoring”         12
RadioRA 2
• ChangedParameterinrstrowto“ModeIndexNumber”under“ActionNumbersand
Parameters”chartandrewrotefootnote                              33
HomeWorks QS
• Changed“monitoringofsensors”to“MonitorsensorsstateswithMonitoringcommand”
under“IntegrationCapabilities”                                  48
myRoom Plus
• Changed“monitoringofsensors”to“MonitorsensorsstateswithMonitoringcommand”
under“IntegrationCapabilities”                                  62
Continuedonnextpage…