Installation Manual

18
Lutron integration protocol
Connection Information
 ProvidesanRS232andEthernetconnectiontocommunicatewithexternalequipment 
CommunicationisthrougheitherRS232orEthernet,butnotbothsimultaneously
 RS232
 TheRS232connectionhasthefollowingcommunicationsettings:
• BaudRate9600/19200/38400/115200(setviadipswitchonunit)
• 8databits
• Noparitybit
• 1stopbit
• Noowcontrol
 Ethernet
 Conguringthecontrolinterfacetocommunicateoveranetworktakesnotonlyknowledge
oftheQSsystem,butofnetworkingaswell Installerswithlimitednetworkingknowledgeare
advisedtocontactanetworkingprofessionalbeforeattemptingtoconnectaQSE-CI-NWK-E
throughanetwork TheinformationbelowwillhelpaninstallercommunicatetheQSE-CI-NWK-E
congurationstoanetworkprofessional
 TheinstallerwillmakeanynecessarychangestothecontrolinterfaceusingtheLutronDeviceIPor
PCsoftwaretoolandthenetworkprofessionalcanmakeanynecessarychangestothenetworking
equipment
Single Ethernet Port
• IEEE®802 3Auto-Sensing10BaseT/100BaseTX
• SupportsMDI/MDIXauto-crossover(nocrossovercableneeded)
• Female8P8C“ComputerRJ-45”socket
• Green“Connect”LED,Amber“Activity”LED
• UseCat5cablingorbetter
TCP / IP Settings
• IPAddress:<staticdefault=192 168 250 1>
• SubnetMask:<staticdefault=255 255 255 0>
• Gateway:<staticdefault=0 0 0 0>
Protocols Used for Integration
• TELNET
Telnet Server
• Usedbythirdpartyequipment(i e touchscreen)
• LimitedtotransferringASCIIcharacters
• TelnetPortnumberis23
• Login #1:nwk
• Login #2:nwk2
QS Standalone (continued)
Integration Access Points (continued)