Installation Manual

23
Lutron integration protocol
QS Standalone (continued)
System Commands (continued)
PROGRAMMINGCommands
PROGRAMMING Command-specific fields
 Action NumbersandParameters:
Description Action Number Parameters
Set(#)addprogrammingtoaphantombutton 1 a)IntegrationID–TheIntegrationIDofthedevice
b)ComponentNumber–Always‘0’forShade
c)Level–Theleveltowhichtheshadebeing
programmedwillgoonactivationofthisbutton
d)Fade–Thetimethezonetakestoreachthe
levelspecied(maximum4hours)
1
e)Delay–ThetimeuntiltheShade/Zonebegins
tochange(maximum4hours)
Set(#)addsceneprogrammingtoaphantom
button
2 a)IntegrationID
b)ComponentNumber(GRAFIKEyeQSScene
controller,EnergiSavrNodearea
2
)
c)SceneNumber
Set(#)clearprogrammingfromaphantom
button
3

3 None
Set(#)congureStop-If-Movingfunctionality
4
4 0=Stop-If-MovingOff
1=Stop-If-MovingOn
Set(#)addprogrammingtoaphantombutton
(Venetianblind,liftandtiltlevels)
5 a)VenetianIntegrationID
b)ComponentNumber(always0)
c)Liftlevel
d)Tiltlevel
Set(#)addprogrammingtoaphantombutton
(Venetianblind,tiltonly)
6 a)VenetianIntegrationID
b)ComponentNumber(always0)
c)Tiltlevel
Set(#)addprogrammingtoaphantombutton
(Venetianblind,liftonly)
7 a)VenetianIntegrationID
b)ComponentNumber(always0)
c)Liftlevel
NOTES
 Amaximumof500programmingassignmentscanbemadeintheQSE-CI-NWK-E
1  NotavailableforShades
2  Ifadevice’sZoneisalreadyassignedtothebutton,youcannotprogramaSceneforthatbutton IfaSceneisalready
programmedforthisbuttonforadevice,youcannotprogramanotherZoneforthisbutton
3  Usebuttonnumber0toclearprogrammingfromallbuttons
4  Usebuttonnumber0tocongureStop-If-Movingfunctionalityonallbuttons
PROGRAMMING Command Formats
Integration ID or Serial # of
the QSE-CI-NWK being used
Use “PROGRAMMING Command-specific fields” tables
to complete these command fields.
Operation
Phantom Button Number
(can be 1–100)
Command
#PROGRAMMING,1,ButtonNumber,ActionNumber,Parameters
Continuedonnextpage…