Installation Manual

32
Lutron integration protocol
MONITORING Command Formats
MONITORING Command-specific fields
 Monitoring Type:
Description Monitoring Type
Set(#)orGet(?)DiagnosticMonitoring 1
Set(#)orGet(?)ButtonMonitoring(ifenabled,buttonactionswillbereported) 3
Set(#)orGet(?)LEDMonitoring(ifenabled,LEDstateswillbereported) 4
Set(#)orGet(?)ZoneMonitoring(ifenabled,zonelevelswillbereported,i e dimmer,
shade,contactclosureoutputlevel)
5
Set(#)orGet(?)ReplyState(ifdisabled,allmessagesFROMtheintegrationaccess
pointwillcease)
11
Set(#)orGet(?)PromptState(ifdisabled,thepromptwillnotbeprintedtotheterminal) 12
Set(#)orGet(?)TemperatureSensorMonitoring 27
Set(#)orGet(?)StateofAllMonitoring(exceptReplyandPrompt) 255
 Action Numbers:
Action Action Number
Enable 1
Disable 2
Example MONITORING Commands
Operation Command String
Execute: #MONITORING,MonitoringType,ActionNumber
DisableDiagnosticMonitoring #MONITORING,1,2<CR><LF>
EnableEventMonitoring #MONITORING,2,1<CR><LF>
Query: ?MONITORING,MonitoringType
IsDiagnosticMonitoringdisabled? ?MONITORING,1<CR><LF>
Response: ~MONITORING,MonitoringType,ActionNumber
DiagnosticMonitoringisdisabled ~MONITORING,1,2<CR><LF>
Setup
Wired
RF
Communication
Repeater Status
1
3
4
2
M
Main Repeater
Power
Repeater Link
COM
9 V
1
N / C
MUX
MUX
2
3
4
AddTest
Integrate Program / Integrate
RS232
Ethernet
USB
RadioRA 2 (continued)
System Commands (continued)
MONITORINGCommands
Use “MONITORING Command-specific fields”
tables to complete these command fields.
Operation
Command
#MONITORING,MonitoringType,ActionNumber