Installation Guide

Sunnata Companion Device
Quick Install Guide
®
24/7 Support: 1.844.LUTRON1 (USA / Canada) +1.888.235.2910 (Mexico)
www.lutron.com/support
INSTALL WITH CONFIDENCE
English
lutron.com/WiringWizard
VIDEO & STEP-BY-STEP INSTRUCTIONSVIDEO & STEP-BY-STEP INSTRUCTIONS
P/N 0302016 REV A
1. Install in accordance with all national and local electrical codes.
2. When no “grounding means” exists in wallbox, the National Electrical Code (NEC®)
allows a control to be installed as a replacement when a plastic faceplate with plastic
fasteners is used, or the circuit is protected by a ground fault circuit interrupter (GFCI).
Lutron wallplates meet this requirement. Cap or remove green wire before screwing
control into wallbox.
3. Protect the control from dust and dirt when painting or spackling the wall.
4. Clean the dimmer with a soft damp cloth only. Do not use any chemical cleaners.
5. For indoor use only.
6. In any 3-way/4-way circuit, use only one main control with up to 4 companions.
7. Maximum wire length between the main control and the farthest companion is
150 ft (45 m).
Important Notes
Limited Warranty:
www.lutron.com/TechnicalDocumentLibrary/369-119_Wallbox_Warranty.pdf ©2021 Lutron Electronics Co., Inc.
Lutron, Sunnata and LED+ are trademarks or registered trademarks of Lutron Electronics Co., Inc., in the U.S. and other countries.
The YouTube icon is a trademark of Google LLC.
3-Way
4-Way
First install the main control as displayed in the main installation guide.
ST-RD for use only with ST-PRO-N. ST-RS for use only with ST-6ANS.
Ground wire
(green)
Disconnect Power
WARNING: SHOCK HAZARD. May result in serious injury or death.
Turn off power at circuit breaker or fuse before installing.
ON
OFF
Please read before installing
ST-RD
ST-RS
1000 W / 8.3 A
Main Control
NOTE: Only the 4-way (middle)
location will have the second red wire.
NOTE: Main dimmer MUST be on the load
side or Companion(s) won’t power up.
Green wire
Common
(tagged)
Brass Screw
Black
Screw
Blue Screw
Ground wire
(bare or green)
Line
Neutral
120 V~
50/60 Hz
Ground
Light
MainCompanion Companion
Line
MainCompanion
Neutral
120 V~
50/60 Hz
Ground
Light
NOTE: Ensure that the same colored wire connects to the blue screw at all locations.
NOTE: Ensure that the same colored wire connects to the blue screw at all locations.
Companion
Middle
Companion
This device complies with part 15 of the FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause undesired operation. Modifications not expressly approved by Lutron ElectronicsCo., Inc.
could void the user’s authority to operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
FCC / IC / IFT Information
120 V~ 50/60 Hz
GroundGround
Ground
OR
14 AWG ONLY
(1.5 mm
2
)
1/2 in
(13 mm)
BA
5 in-lbs
(0,55 N • m)
12 –14 AWG
(2.5 – 1.5 mm
2
)