Installation Guide

OFF
ON
WARNING: ELECTRIC SHOCK HAZARD.
May result in Serious Injury or Death. Turn off
power at circuit breaker or fuse before installing.
1
Turn power OFF at circuit breaker
5
Connect the new MASTER dimmer and re-wire OTHER EXISTING switch
6
Mount all devices using the provided screws
Troubleshooting
7
Turn power ON at circuit breaker
2
Remove (but do not disconnect) existing devices
3
Mark wire on the COMMON terminal
See step 9, “Set Low-End Trim” on reverse side for details of setting the low-end trim.
1. Triple tap the OFF button rapidly holding on the last press.
2. Continue holding until the light bar and the lighting load begin to raise from low to high in about 3 seconds.
3. Immediately triple tap the OFF button again.
4. The light bar and lighting load will begin to raise from low to high 3 times, the lights turn off, and then turn back on to
high-end.
4
Disconnect wires from the switch at the dimmer location
On both existing devices, mark the wire (for example, using electrical tape) that is connected
to the screw that is a different color (typically black) than all the others. The different
color screw may be on either side of the switch. This screw terminal may also be labeled
“COMMON” or “COM”. Does not include the ground screw.
Rear / side view of existing device
8
Adjust dimming range for LEDs and CFLs
Restoring Default Settings
OPTIONAL FOR INCANDESCENT / HALOGEN
+
COM
Symptom Probable Cause and Action
LEDs or CFLs do not dim, have
a poor dimming range, or they
flicker / flash
1. Verify light bar and switch operation, see Step 8 on reverse side
2. To confirm that the bulbs are Lutron compatible, see our LED compatibility
tool at www.lutron.com/LEDfinder
3. Adjust the low-end trim, see Step 9 on reverse side
Audible buzzing
(common with LEDs)
To confirm that the bulbs are Lutron compatible, see our LED compatibility tool
at www.lutron.com/LEDfinder
Dimmer does not turn on
(light bar not illuminated)
1. Check breaker
2. Check that the bulb is installed and has not failed
3. For 3-way:
a. Check the wiring of the dimmer in Location 1. See step 5 on this side
b. Did you re-wire the switch in Location 2? See step 5 on this side for
Location 2 re-wiring
4. Check that the FASS airgap switch is pushed in
Indicator LEDs of the light bar are
too bright or too dim
Change the intensity of the Indicator LEDs using the Advanced Programming
feature. Please see the Sunnata Advanced Programming Mode Application Note
#734 (P/N 048734) at www.lutron.com/SunnataSupport
For additional troubleshooting, please visit www.lutron.com/SunnataSupport
.
W2
W1
.
.
Non-black wire
Different
color
screw
Tagged
wire
Tagged wire
Yellow jumper wire
Before After
Ground wire
(green or bare copper)
W1
W1
W2
W2
.
Location 1
Location 2
Black
Tagged wire
Non-black wire
Blue
Black
Green
(ground)
W1
W2
Different
color screw
3 sec
Off Off Off
For lights controlled from two locations
(Dimmer not compatible with lights controlled from three or more locations)