Drawing

4
|
Lutron® 24/7 Technical Support—800.523.9466
product specifications
08.30.11
369-303b
Load Type and Capacity
HomeWorks® QS RF Hybrid seeTouch® Keypads
Load Type Minimum Load Not
Ganged
End of
Gang
Middle
of Gang
With Neutral Without Neutral
Incandescent
1
15 W 50 W 450 W 350 W 250 W
MLV
2
15 W / VA 50 W / VA
350 W /
450 VA
250 W /
350 VA
200 W /
250 VA
1 Load Type: RF Hybrid Keypads are designed for use with permanently installed incandescent, magnetic low-voltage, or tungsten halogen
only. To reduce the risk of overheating and possible damage to other equipment, do not install RF Hybrid Keypads to control receptacles
or motor-operated appliances.
2 Low-Voltage Applications: Use RF Hybrid Keypads with magnetic (core and coil) low-voltage transformers only. Not for use with
electronic (solid-state) low-voltage transformers. Operation of a low-voltage circuit with lamps inoperative or removed may result in
transformer overheating and premature failure. Lutron strongly recommends the following:
 •Do not operate low-voltage circuits without operative lamps in place.
 •Replace burned-out lamps as quickly as possible.
 •Use transformers that incorporate thermal protection or fused transformer primary windings to prevent transformer failure due to overcurrent.
Control Phase Adaptive
Power Modules
(PHPM-PA-120-WH
& PHPM-PA-DV-WH)
3-wire Fluorescent
Power Modules
(PHPM-3F-120-WH
& PHPM-3F-DV-WH)
Switched Power
Module
(PHPM-SW-DV-WH)
0-10 V Interface
and Switching
Module
(GRX-TVI)
HQRD-H1RLD
HQRD-H2RLD
HQRD-H3BSRL
HQRD-H4S
HQRD-H5BRL
HQRD-H6BRL
   
Compatible Power Boosters and Load Interfaces
Some local controls can be used to control power boosters or load interfaces. Up to three power
boosters or load interfaces can be used with one control. See table below for a list of compatible
power boosters and load interfaces.