Installation Guide

INSTALLATION INSTRUCTIONS
FOR MOUNTING
LUVERNE GRILLE GUARD WITH THE FOLLOWING MODEL NO.:
331722/331723, 341722/341723 , 341724/341725 ON:
2017 AND NEWER F-250 – F-550 SUPER DUTY SERIES TRUCKS
1. READ THE INSTRUCTIONS COMPLETELY AND CHECK TO MAKE SURE THAT ALL OF THE
REQUIRED PARTS ARE ON HAND BEFORE STARTING THE INSTALLATION. THE CARTON
SHOULD CONTAIN:
(1) OUTER RING PACKAGE
(1) OUTER RING ASSEMBLY
(1)UPRIGHT PACKAGE
(1) UPRIGHT ASSEMBLY, LH
(1) UPRIGHT ASSEMBLY, RH
(1) MOUNTING BRACKET, LH
(1) MOUNTING BRACKET, RH
(1) FRAME BRACE, LH
(1) FRAME BRACE, RH
(2) UPRIGHT COVERS (CHROME GUARDS ONLY)
(1) HARDWARE PACKAGE
(1) CUSTOMER SERVICE PACKAGE
REFER TO SHEETS #1, #2, #3, #4 & #5 FOR GUARD ASSEMBLY & INSTALLATION
INSTRUCTIONS 2-13
2. ON THE LEFT SIDE OF THE VEHICLE, LOOSEN AND REMOVE THE TWO BOLTS IN THE FACE OF
THE BUMPER, THAT SECURE THE BUMPER TO THE FRAME, ALSO REMOVE THE TWO BOLT
RETAINER WASHERS BETWEEN THE BUMPER MOUNTING PLATE AND THE FRAME MOUNTING
PLATE.
3. IF THE VEHICLE HAS AN ANTI-CLIMB OVER BRACKET REMOVE THE OUTSIDE BOLT SET THAT
ATTACHES IT TO THE FRAME.
4. INSTALL THE LEFT HAND T-BOLT ASSEMBLY (ITEM #8) THROUGH THE HOLES IN THE FRAME
FROM THE INSIDE. INSTALL TWO M12 X 1.75 FLANGE NUTS (ITEM #19) ON THE BOLTS AND
TIGHTEN THE NUTS.
5. INSTALL TWO M12 X 1.75 FLANGE NUTS (ITEM #19) ON THE BOLTS WITH THE FLANGE FACING
TO THE OUTSIDE AND TIGHTEN THE NUTS. (NOTE: IF THE VEHICLE DOES NOT HAVE ANTI-
CLIMB OVER BRACKETS YOU MAY HAVE TO ADJUST THIS NUT OUT TO GET THE HOLES
IN THE BRACKET TO MATCH THE HOLES IN THE BUMPER.) MOUNT THE LEFT HAND FRAME
MOUNTING BRACKET BRACE (ITEM #6) ONTO THE BOLTS AND CHECK TO MAKE SURE THAT
THE HOLES IN THE BRACE MATCH UP TO THE HOLES IN THE BUMPER. CHECK TO MAKE SURE
THE HOLES WILL ALLOW THE ½” CARRIAGE BOLTS TO COME THROUGH THE FACE OF THE
BUMPER.. INSTALL TWO M12 NUTS (ITEM #19) TO RETAIN THE BRACKET. LEAVE LOOSE AT
THIS TIME.
202979 SHEET 1 OF 5 23SEP16