Installation Guide

6. ON THE LEFT HAND MOUNTING BRACKET (ITEM #4), INSTALL THE TWO 1/2”-13 X 2” CARRAGE
BOLTS (ITEM #13) IN THE HOLES OF THE MOUNTING BRACKETS, PLACE THE 5/8” FLAT
WASHERS (ITEM #23) ON THE BOLTS AND INSTALL THE TWO PUSH NUTS (ITEM #20) ON THE
BOLTS.
7. INSERT THE ASSEMBLED BRACKET INTO THE HOLES IN THE BUMPER AND FASTEN WITH 1/2”
FLAT WASHERS (ITEM #24), 1/2” LOCK WASHERS (ITEM #21) AND 1/2” HEX NUTS (ITEM #18) AS
SHOWN IN FIG. 1 & 2. HAND TIGHTEN ONLY AT THIS TIME.
8. REPEAT STEPS 2 THRU 9 FOR THE OPPOSITE SIDE.
9. INSTALL THE UPRIGHTS (ITEM #2 & #3) ONTO THE MOUNTING BRACKETS (ITEM #4 & #5) AND
FASTEN WITH THE 1/2”-13 X 3” CARRIAGE BOLTS (ITEM #14), 1/2” SAE FLAT WASHERS (ITEM
#25) AND 1/2”-13 ACORN NUTS (ITEM #17) .
10. INSTALL THE RING (ITEM #1) BY LOWERING IT DOWN FROM THE TOP AND BEHIND THE
UPRIGHTS, (TAKING CARE NOT TO SCRAPE THE ENDS OF THE RING AGAINST THE SIDE OF THE
VEHICLE.) AND SLIDE THE RING INTO THE NOTCHES OF THE UPRIGHTS. FASTEN WITH THE
UPRIGHT COVERS (ITEM #22) (CHROME GUARDS ONLY), 7/16”-14 X 1-1/2” HEX BOLTS (ITEM
#15) AND 7/16” FLAT WASHERS (ITEM #26) INTO THE 7/16”-14 CAPTIVE NUTS (ITEM #27) IN THE
UPRIGHT MOUNTING PLATES.
11. CHECK THAT THE GRILL GUARD IS CENTERED AND VERTICAL ON THE BUMPER AND THE
UPRIGHTS ARE STRAIGHT UP AND DOWN. THEN TIGHTEN THE FOUR 7/16” BOLTS (ITEM #15)
SECURING THE RING TO THE UPRIGHTS.
12. TIGHTEN THE FOUR 1/2” NUTS (ITEM #18) SECURING THE UPRIGHTS TO THE BUMPER
MOUNTING BRACKET AND THE MOUNTING BRACES.
13. TIGHTEN THE 1/2”-13 NUTS (ITEM #19) THAT SECURE THE MOUNTING BRACKET BRACE (ITEM
#6 & #7) TO THE FRAME.
202979 SHEET 2 OF 5 23SEP16