Operation Manual

38
Maintenance and storage
• Ensure that all nuts, bolts and screws are
tightened and the tool is in a safe operat-
ing state.
• Check the grass collection equipment
regularly for wear or for loss of functional-
ity.
• For safety reasons, replace worn or dam-
aged parts.
• Remember that when using a tool with
multiple blades, moving one blade may
lead to the other blades rotating.
• When adjusting the machine, make sure
that no fingers are trapped between the
moving blades and fixed parts of the
machine.
• Allow the motor to cool down before you
put the machine away.
• When maintaining the blades, remember
that even if the power source is deacti-
vated, the blades can still be moved.
• For safety reasons, replace worn or dam-
aged parts. Only use original spare parts
and accessories.
The variant of the product sold in Switzerland
may only be used in Switzerland, as it is
equipped with a Swiss plug.
You can identify the variant by means of the
item number on the product (the instructions
always contain all item numbers):
• Item number Switzerland: 468 449,
468 604
• Item number in other EU countries:
106 542, 106 543, 106 544, 106 545
The device at a glance
► P. 3, item 1
1. Upper retaining bracket
2. Switch-on lever
3. Quick release lever
4. Lever (for cutting height adjustment)
5. Wheel left
6. Motor
7. Wheel (front)
8. Wheel (rear)
9. Cable grip
10. Cable clamp
11. Grass collector
12. Safety flap
13. Lower retaining bracket
14. Mains plug
15. Safety lock
Scope of supply
• Instructions for use
• Lawn mower
• Upper retaining bracket
• Lower retaining bracket
• Grass collector
• Bag with mounting material
Assembly
Mounting the lower retaining bracket
► P. 4, item 2
– Mount the lower retaining bracket(13) as
illustrated.
– Repeat the procedure for the other side.
Mounting the upper retaining bracket
► P. 4, item 3
– Mount the upper retaining bracket(1) as
illustrated.
– Repeat the procedure for the other side.
– Adjust the angle and fix using the quick
release lever(3).
– Attach the cable using cable clamp(10)
onto the lower retaining bracket(13).
Attaching the collecting sack
► P. 4, item 4
– Clip the rubber lip (16) of two sides of the
cloth grass collecting bag onto the wire
bar (17).
– Fully insert the rods of the wire bar into
the slots (18) on either side of the plastic
base of the grass collecting bag.
– There is a hole (19) in the bottom of the
grass collector to hang it up if required.
The grass collecting bag is also designed
to collapse into a compact size to reduce
storage when the lawnmower is not in
use.
DANGER! Risk of death through
electric shock! The use of this vari-
ant outside Switzerland is not per-
missible for safety reasons, as this
poses a risk of electric shock or fire.
WARNING! Risk of injury! Place the
product horizontally on a stable, suf-
ficiently load-bearing and level sur-
face.
Note: It must be possible to close
the quick release levers completely.
If necessary, slightly loosen the self-
locking nuts.
GB
Rasenmaeher_106542_106543_106544_106545_468449_468604.book Seite 38 Donnerstag, 10. November 2016 1:57 13