User manual

Door reversal
To make it easier to load or unload the laundry
the door can be reversed.
This operation must be carried out by
qualified personnel.
Operate as follows:
- Remove the door by unscrewing the two screws
(1) fastening the hinge to the cabinet (Fig. A).
- Remove tang (2) by pulling it downwards
(Fig. A) and refit it on the lower part of the door.
- Remove screws (3), plastic plates (4) and (5)
(Fig. A) using a screwdriver. Take care not to
damage the cabinet.
- Refit the pieces (3), (4) and (5) on the opposite
side (Fig. B).
- Refit the door by screwing in the two screws (1)
which fasten the door to the cabinet (Fig. B).
Stacking kit
A special stacking kit is available through your
dealer, to enable the mounting of the dryer on
top of your washing machine.
Electrical connection
(for WT 75 Prod. No. 916770541)
This machine is designed to operate on a 220-
230 V, single-phase, 50 Hz supply.
Check that your domestic electrical installation
can take the maximum load required (2.2 kW),
also taking into account any other appliances in
use.
Connect the machine to an earthed socket, in
accordance with current wiring regulations.
The manufacturer declines any
responsibility for damage or injury
through failure to comply with the
above safety precaution.
7
1
2
3
4
P0883
5
A
1
2
3
4
P0884
5
B
P0280
ENGLISH