Installation & Assembly

Page: 1

Instruction, Use & Care Manual

Please save this manual for future reference.

Thank you for purchasing this Winsome House product. This product has been manufactured with the highest standards

of safety and quality.

Product Name:

Solar Motion Sensor Wall Light

SKU #:

WHSL444

Operating Instructions

BEFORE USING THIS PRODUCT: READ, UNDERSTAND AND FOLLOW THESE INSTRUCTIONS.

How Your Solar Motion Sensor Light Works:

During the day, the solar charge panel included with this LED Solar Motion Sensor Wall Light converts sunlight into

electricity recharging the batteries. Using this stored energy, the LED light turns on automatically at night when motion is

detected.

The light works with a built-in PIR (Passive InfraRed) sensing device which is continuously scanning for heat-source moving

in its detection scope. Once a heat source (such as a human or a car) is detected in that area, the light switches on

immediately and automatically to illuminate your pathways, steps, patios, porches, or anywhere you select for safety,

convenience, and security. The light remains on while the moving heat source stays in the detecting scope.

 Motion-activated light

Choosing a Location for Your Solar Motion Light:

 The solar light must be located in a position where it can get direct sunlight on the solar panel, and generally free

from cover and shade. When locating a suitable position for the unit, remember that it detects an area of about 90

degrees vertically and horizontally, with a range of over 5 meters (16.4 ft). See figure above.

 Make sure that the photo sensor on the lamp body is not going to be affected by another light source, otherwise the

light will not illuminate at dusk.

 The solar light must be left to charge for two sunny days before first time use so that the best results are achieved.

PAGE 1
Instruction, Use & Care Manual Please save this manual for future reference. Thank you for purchasing this Winsome House product. This product has been manufactured with the highest standards of safety and quality. Product Name: Solar Motion Sensor Wall Light SKU #: WHSL444 Operating Instructions BEFORE USING THIS PRODUCT: READ, UNDERSTAND AND FOLLOW THESE INSTRUCTIONS.
PAGE 2
Instruction, Use & Care Manual Please save this manual for future reference. Product Name: Solar Motion Sensor Wall Light SKU #: WHSL444 Installation Tips   Choose a location where the solar panel can receive sunlight. Install the wall anchors first, then use the metal screws to mount the LED light with the solar panel to the flat surface (wall, step, wood post). Replacing the Batteries For best results, batteries should be replaced every 12 months.
PAGE 3
Instruction, Use & Care Manual Please save this manual for future reference. Product Name: Solar Motion Sensor Wall Light SKU #: WHSL444 Technical Specifications LED Light Setting: 200 Lumen Rechargeable Battery Type: Solar Panel: High Light activation (range): Charge Time (minimum): Motion Sensor Range: 8650 Li-ion 1200mAh 3.7V Amorphous silicon 20 seconds 6 Hours 5 meters (16.