Instructions / Assembly

072018 Rev. 2Luxier
4
Installation-SitePreparation
Installation-DrainAssembly
• Provide sucient oor support. Check the oor at the installation site and make repairs as
needed.
• Waterproof the oor is highly recommended. Finished oor must be level.
• Provide adequate clearance on all sides of the bathtub.
• Minimum of 2 inch waste drain pipe is required.
NOTICE:Itisrecommendedtodrytthepartsbeforeinstallation.
1. Place a large drop cloth on the oor to protect the bathtub.
2. With help, lift the bathtub and place it on its side. Secure the bathtub to prevent it from moving.
3. Assemble the elbow connector as shown in gure 1. Wrap PTFE tape to the thread on the drain
body and thread on the elbow connector (#07)
4. Upright the bathtub and carefully move it to the nal installation position. (NOTICE: Do not drag
the bathtub on the oor as it will damage the bathtub.)
5. Connect the exible drain pipe (#08) to the elbow connector and connect the other end to the
waste pipe.
Drain Body (01)
Flange Gasket (02)
Overow (05)
Overow Channel (06)
Flexible Drain Pipe (08)
Elbow Connector (07)
Drain Gasket (03)
Locking Nut (04)
Fig. 1