Full Product Manual

4
KTS20 Rev.1 07/2018
Luxier USA
Installation
A. Shut o water supply at the valves.
Remove old faucet and clean the
mounting surface for installation of new
faucet.
B. Remove the quick connector.
A
C. Insert the faucet through the
mounting hole with the base. Install
rubber washer, metal washer and the
locking nut onto the shank. Secure the
locking nut by tighten the 2 screws.
CB
D. Install the quick connector back onto
the pipe and attach the pull down hose
to the quick connector. Make sure the
connection is tight to prevent water
from leaking. Install counterweight on
the pull down hose.
E. Apply Teon (TPFE) tape to the male
end of the connector on the faucet.
Attach the supply hoses to the faucet.
Use an adjustable wrench to tighten the
tting. (NOTE: Do not over tighten the
connections)
F. Turn on water supply to check for
leaks at all connection. Remove spray
head from the pull out hose and let the
water run for about 1 minute and check
for leaks. Reattach the spray head.
E
F
01. Sprayer Head
02. Faucet Body
03. 2.5 mm Allen key
04. Cover
05. Setscrew
06. Handle
07. Trim Cap
08. Bonnet
09. Cartridge Retaining Cover
10. Cartridge
11. Base
12. O ring
13. Shanke
14. Rubber Washer
15. Steel Washer
16. Locking Nut
17. Quick Connector
18. 1/2”-14 NPSM Connector
19. Screws
20. Counterweight
21. Pull Out Hose
NOTE: This faucet does not include a pair of water supply hoses. A pair of water supply hoses with 1/2”
FIP ttings are required for installation
D
3
1
2
4
5
6
7
8
9
10
11
21
12
13
14
15
16
17
18
19
20