Use and Care Manual

ManualsBrandsLuxier ManualsKitchenKitchen Bathroom Sink Deck-Mount Soap or Lotion Pump Dispenser in Brushed Nickel

LX Rev. B 102014

Installation Guide

1. Insert the pump base through the mounting hole. Make sure the base is sitting

on the rubber washer.

2. Install the rubber washer and lock nut from below. Tighten the lock nut to

secure the pump base.

3. Attach the plastic bottle to the base. Do not over tighten the bottle.

4. Fill bottle with liquid from the top.

5. Attach the tube to the pump body and insert the assembly into the pump base.

6. Prime the pump and it is ready to use.

Pump Head

Pump Body

1 1/8” Hole Size

Max. Deck Thickness 1”

Tube

Pump Base

Rubber Washer

Mounting Surface

Lock Nut

Bottle

Maintenance Guide

Troubleshooting

Instruction

1. Carefully read the cleaner product label and follow the instructions to ensure

the cleaner is safe for use on this soap dispenser.

2. Regular cleaning can prevent soap build up on pump head and body.

3. Use a mild detergent such as liquid dishwashing soap and warm water for clean-

ing.

4. Do not use abrasive / harsh chemical when cleaning the xture as they will dam-

age and dull the nish.

5. Test the cleaner on a small area before using on the entire surface.

6. Do not leave the cleaner on the xture longer than necessary.

7. When using spray cleaners, spray rst onto a soft cloth or sponge. Never spray

directly onto the faucet as droplets can enter openings and gaps and cause

damage.

8. After cleaning, rinse thoroughly with clean water to remove any cleaner residue.

Push down directly

on the pump head

Do not push down

on the spout

Problem Probable Cause Remedy

Pump Does not dispense

soap

1. Liquid may be too thick

2. Pump mechanism may be

clogged

3. Spring mechanism is not

working

4. Dispenser has not been used

in a long period of time

1. Dilute the soap with some

water

2. Clean pump head and tube

with running water

3. Replace pump head spring

4. Clean pump head and parts

with running water

Pump feel sluggish

1. Soap may have dried out and

clogged the pump head

2. Spring mechanism is not

working

1. Clean pump head and parts

with running water

2. Replace pump spring

Summary of content (1 pages)

PAGE 1
Installation Guide 1. Insert the pump base through the mounting hole. Make sure the base is sitting on the rubber washer. 2. Install the rubber washer and lock nut from below. Tighten the lock nut to secure the pump base. 3. Attach the plastic bottle to the base. Do not over tighten the bottle. 4. Fill bottle with liquid from the top. 5. Attach the tube to the pump body and insert the assembly into the pump base. 6. Prime the pump and it is ready to use. Pump Head Pump Body Maintenance Guide 1.