Luxier SP22-SS Features - Stunning stylish European inspired design - Durable stainless steel frame construction - 8 body massage jets - 4 stage shower functions (Rainfall, Waterfall, Massage Spray, Hand Shower) - Contemporary brass hand shower Luxier 1 SP22-SS Rev.
Thank you for purchasing Luxier products. Please read the information below and keep this installation guide for future reference. If you require assistance, please contact our customer service department at 1-877-711-8828, Monday - Friday 9AM - 5PM Pacific Time. Or by email at support@luxierusa.com.
Attention • This installation guide is subject to change without notice, please contact us to request the most updated version of this installation guide. • This is a general installation guideline, actual installation may vary. Consult a professional if necessary. • Product drawings in this installation guide is for illustration purpose only. Actual product may vary depends on model. • Always take extra precautions and wear appropriate safety equipment when installing this product.
Fig. A * Shower panel drawing on this page is for illustration purpose only. Actual product may vary depends on model. Recommended 10” - 12” It is recommened to aim the top horizontal body jets at the chest area of the user for optimal showering experience. The installation height of the outlet box is approximately the total distance of measurement A and measurement B. Approximate shower inlet valve location approx.
Technical / Flow Rate Data Recommended Operating Pressure: 50 - 80 psi Approx. flow rate: 3.38 gpm at 80 psi 495mm 19.49” 200mm 7.87” 1550mm 61.02” 800mm 31.5” 480mm 18.9” 260mm 10.24” 72.5mm 2.85” *All Measurements are Approximate Luxier 5 SP22-SS Rev.
Parts List 1 7 8 9 2 4 3 5 6 01. Shower Panel Body 02. Hand Shower 03. Wall Mount Hand Shower Cradle 04. O rings 05. Hand Shower Hose 06. Hand Shower Water Connector 07. Screws X 4 08. Mounting Brackets X 2 09. Wall Anchors X 4 Luxier 6 SP22-SS Rev.
Installation 1. Mark the positions of the 2 brackets on the wall and set a side the panel. (NOTE: The distance between the two brackets should be 800mm or 31.5”) 800mm 31.5” 1” 2. Using a drill with a tile bit, drill the hole slowly into the tile. Do not drill into any piping or wiring in the wall. Insert the anchors into the wall. (NOTE: Before installing the wall anchors, use a small piece of painters tape or masking tape over the drill area. This will prevent damages to the tile) 3.
Installation (cont.) 4. Apply thread sealant tape to the threading on the shut off valves before connect both hot and cold water supply hoses to the valves. Turn on the valves and check all connections for possible leaks. 5. Hang the unit on the wall to complete the installation. Make sure the unit is seated properly. Apply silicon sealant on left and right sides of the shower panel. (NOTE: do not seal the bottom of the panel, this will allow any possible future leaks to drain out the panel) 6.
Operation 1. Turn the water control valve to set the desired water temperature. 2. Select the water function by turning the selector to the corresponding marking. All water functions can be turned on Function Selectors the same time if there is enough water pressure supplied to the shower panel. Water Control Water Functions Overhead Jets Handheld Shower Horizontal Body Jets Overhead Waterfall Maintenance Guide Please follow the cleaning material manufacturer’s instructions.