Luxier SP31-SS Features - Stunning stylish European inspired design - 4 shower functions (Rainfall, Waterfall, Massage Spray, Hand Shower) - Durable stainless steel frame construction - Contemporary brass hand shower Luxier 1 SP31-SS Rev.
Thank you for purchasing Luxier products. Please read the information below and keep this installation guide for future reference. If you require assistance, please contact our customer service department at 1-877-711-8828, Monday - Friday 10AM - 5PM Pacific Time. Or by email at support@luxierusa.com.
Attention • This installation guide is subject to change without notice, please contact us to request the most updated version of this installation guide. • This is a general installation guideline, actual installation may vary. Consult a professional if necessary. • Product drawings in this installation guide is for illustration purpose only. Actual product may vary depends on model. • Always take extra precautions and wear appropriate safety equipment when installing this product.
Fig. A Recommended 10” - 12” It is recommened to aim the top horizontal body jets at the chest area of the user for optimal showering experience. The installation height of the outlet box is approximately the total distance of measurement A and measurement B. Approximate shower inlet valve location laundry outlet box (This is the distance from the bottom edge of the shower panel to the valve.
Technical Data Recommended Operating Pressure: 50-80 PSI 200mm 7.87” 495mm 19.49” 1550mm 61.02” 770mm 30.31” 690mm 27.17” 500mm 19.69” 260mm 10.24” 72.5mm 2.85” *All Measurements are Approximate Luxier 5 SP31-SS Rev.
Parts List 1 8 9 2 10 3 4 5 6 7 01. Shower Panel Body 02. Hand Shower Water Supply Connector 03. Locking Nut 04. Hand Shower 05. Hand Shower Cradle 06. Rubber Washer 07. Hand Shower Hose 08. Screws X 4 09. Mounting Brackets X 2 10. Wall Anchors X 4 Luxier 6 SP31-SS Rev.
Installation 1. Install hand shower connector and attach PVC tubing to complete the connection. 2. Mark the positions of the 2 brackets on the wall and set a side the panel. (NOTE: The distance between the two brackets should be 770mm or 30.31”) 770mm 30.31” 1” Luxier 3. Using a drill with a tile bit, drill the hole slowly into the tile. Do not drill into any piping or wiring in the wall. Insert the anchors into the wall.
Installation (cont.) 4. Secure the mounting brackets to the wall. 5. Apply thread sealant tape to the threading on the shut off valves before connect both hot and cold water supply hoses to the valves. Turn on the valves and check all connections for possible leaks. 6. Hang the unit on the wall to complete the installation. Make sure the unit is seated properly. Apply silicon sealant on left and right sides of the shower panel.
Installation (cont.) 7. Connect hand shower hose to the main panel body. Attach the hand shower to the hose. (NOTE: Install the rubber washer to prevent leak.) Luxier 9 SP31-SS Rev.
Operation 1. To operate the unit lift the handle on the bottom knob to turn on the water. 2. Turn the top knob to select desired water function. Overhead Rainfall Shower Handheld Shower Horizontal Body Jets Maintenance Guide Please follow the cleaning material manufacturer’s instructions. In addition, pay attention to the following points: 1. Regular cleaning can prevent mineral build up on shower head and handheld shower. 2.
