SP38-CEC Features - Stunning stylish European inspired design - Durable stainless steel frame construction - Square stainless steel thin profile shower head - 3 stage shower functions (Rainfall, Massage Spray, Hand Shower) - Contemporary brass hand shower - Tempered glass shelf Luxier 1 SP38-CEC Rev.
Thank you for purchasing Luxier products. Please read the information below and keep this installation guide for future reference. If you require assistance, please contact our customer service department at 1-877-711-8828, Monday - Friday 9AM - 5PM Pacific Time. Or by email at support@luxierusa.com.
Attention • This installation guide is subject to change without notice, please contact us to request the most updated version of this installation guide. • This is a general installation guideline, actual installation may vary. Consult a professional if necessary. • Product drawings in this installation guide is for illustration purpose only. Actual product may vary depends on model. • Always take extra precautions and wear appropriate safety equipment when installing this product.
Fig. A * Shower panel drawing on this page is for illustration purpose only. Actual product may vary depends on model. Recommended 10” - 12” It is recommened to aim the top horizontal body jets at the chest area of the user for optimal showering experience. The installation height of the outlet box is approximately the total distance of measurement A and measurement B. Approximate shower inlet valve location approx.
Technical Data Recommended Operating Pressure: 50 - 80 psi Flow Rate: 1.8 gpm at 80 psi (NOTE: This product is equipped with a water saving device with restricted flow rate as required by the state of California. To learn more about this water saving feature, please contact our customer service department.) 340 mm 13.39” 220 mm 8.66” 1300 mm 51.18” 710 mm 27.95” 480 mm 18.90” 270 mm 10.63” 60 mm 2.4” * Drawings not to scale. All measurements are approximate * Luxier 5 SP38-CEC Rev.
Parts List 1 2 3 4 5 8 15 14 13 6 9 10 11 12 01. Shower Arm Flange 02. Shower Arm 03. Shower Head 04. Rubber Gasket 05. Shower Panel Body 06. Glass Shelf 07. Rubber Gasket 08. Locking Nut 09. Hand Shower 10. Hand Shower Cradle 11. Rubber Gasket 12. Hand Shower Hose 13. Screw x 4 14. Mounting Bracket x 2 15. Wall Anchors x 4 Luxier 7 6 SP38-CEC Rev.
Installation 1. Attach shower arm assembly (1) to the panel body with the locking nut (2). Connect the Rainfall Shower Water Connector (3) after the shower arm is attached to the shower panel. 2 3 1 2 3 4 5 2. Install hand shower cradle (1) to the shower panel by installing the rubber washer (2) and the locking nut (3) and attach white plastic hose tube connector (5) with PVC tubing to complete the connection. (NOTE: Make sure the silicon gasket (4) is seated properly inside the connector.) 1 3.
Installation (cont.) 5. Secure the mounting brackets to the wall. 6. Apply thread sealant tape to the threading on the shut-off valves before connect both hot and cold water supply hoses to the valves. IMPORTANT : - Make sure the water supply hoses are connected to the corresponding shut-off valves - i.e. cold water hose to the cold water valve and hot water hose to the hot water valve. The thermostatic valve will not function properly if the hoses are installed incorrectly.
Installation (cont.) 8. Attach shower head. (NOTE: PTFE tape on the thread to prevent leaking) 9. Connect hand shower hose to the main panel body and connect the hand shower wand to the hose. Make sure the silicon gaskets are seated properly to prevent water leak. 10. Loosen the set screws under the anchors to insert the glass shelf. Tighten the set screws to secure the glass shelf. (WARNING: Do not place heavy objects on the glass shelf.
Operation Function Selector 1. Turn the temperature control knob to set the desired water temperature. 2. Select the desired water function by turning the selector to the corresponding marking. Cold Temperature Control Hot IMPORTANT: The range of the control knob is limited in both clockwise and counter-clockwise directions. DO NOT force to turn the knob pass its limit. Overturning the control will damage the thermostatic valve making it fail to regulate temperature.
Appendix A. This diagram provides a general idea of the outlet box. Actual installation may vary. Consult a professional if necessary. You may also refer to the following link for a video demonstration of the general installation process. NOTE: Luxier is not affiliated with the owner of the video. The purpose of this video is meant to provide a visual concept of the shower outlet box to speed up the installation process. All images are copyright to their respective owners. https://youtu.
