SP21-CEC Features - Stunning stylish European inspired design - Durable stainless steel frame construction - Square stainless thin profile shower head - 3 stage shower functions (Rainfall, Massage Spray, Hand Shower) - Contemporary brass hand shower - Tempered glass shelf * Proper water pressure is required for simultaneous operations Luxier 1 SP21-CEC Rev.
Thank you for purchasing Luxier products. Please read the information below and keep this installation guide for future reference. If you require assistance, please contact our customer service department at 1-877-711-8828, Monday - Friday 9AM - 5PM Pacific Time. Or by email at support@luxierusa.com.
Attention • This installation guide is subject to change without notice, please contact us to request the most updated version of this installation guide. • This is a general installation guideline, actual installation may vary. Consult a professional if necessary. • Product drawings in this installation guide is for illustration purpose only. Actual product may vary depends on model. • Always take extra precautions and wear appropriate safety equipment when installing this product.
Fig. A * Shower panel drawing on this page is for illustration purpose only. Actual product may vary depends on model. Recommended 10” - 12” It is recommened to aim the top horizontal body jets at the chest area of the user for optimal showering experience. The installation height of the outlet box is approximately the total distance of measurement A and measurement B. Approximate shower inlet valve location approx.
Technical Data Recommended Operating Pressure: 50 - 80 psi Flow Rate: 1.8 gpm at 80 psi (NOTE: This product is equipped with a water saving device with restricted flow rate as required by the state of California. To learn more about this water saving feature, please contact our customer service department.) 180mm 7.1” 355mm 13.98” 1,400mm 55.11” 815mm 32.09” 635mm 25” 290mm 11.42” 210mm 8.27” 70mm 2.76” * Drawings not to scale. All measurements are approximate * Luxier 5 SP21-CEC Rev.
Parts List 3 1 2 16 17 4 20 19 18 5 13 14 15 6 7 12 01. Shower Panel Body 02. Flange 03. Shower Arm 04. Shower Head 05. Glass Shelf 06. Hand Shower 07. Hand Shower Cradle 08. Hand Shower Hose 09. Water Supply Hose 10. Check Valves 11. Thermostatic Valve 12. Diverter 13. Hand Shower Water Connector 14. Locking Nut 15. Gasket 16. Locking Nut 17. Rainfall Shower Water Connector 18. Screws X 4 19. Mounting Brackets X 2 20. Wall Anchors X 4 Luxier 8 11 10 9 6 SP21-CEC Rev.
Installation 1. Attach shower arm assembly (1) to the panel body with the locking nut (2). Connect the Rainfall Shower Water Connector (3) after the shower arm is attached to the shower panel. 2 3 1 2 3 4 5 2. Install hand shower cradle (1) to the shower panel by installing the rubber washer (2) and the locking nut (3) and attach white plastic hose tube connector (5) with PVC tubing to complete the connection. (NOTE: Make sure the silicon gasket (4) is seated properly inside the connector.) 1 3.
Installation (cont.) 5. Secure the mounting brackets to the wall. 6. Apply thread sealant tape to the threading on the shut-off valves before connect both hot and cold water supply hoses to the valves. IMPORTANT : - Make sure the water supply hoses are connected to the corresponding shut-off valves - i.e. cold water hose to the cold water valve and hot water hose to the hot water valve. The thermostatic valve will not function properly if the hoses are installed incorrectly.
Installation (cont.) 8. Attach shower head. (NOTE: PTFE tape on the thread to prevent leaking) 9. Connect hand shower hose to the main panel body and connect the hand shower wand to the hose. Make sure the silicon gaskets are seated properly to prevent water leak. 10. Loosen the set screws under the anchors to insert the glass shelf. Tighten the set screws to secure the glass shelf. (WARNING: Do not place heavy objects on the glass shelf.
Operation 1. Turn the temperature control knob to set the desired water temperature. The control is preset to maximum temperature of Function Selector 100.4 degrees Fahrenheit. To set higher water temperature, push down the safety pin and turn the dial counterclockwise to the desired temperature mark. (IMPORTANT: Scalding may occur if bypass the safety pin, use this control with caution) Temperature Control 2. Select the desired water function by turning the selector to the corresponding marking. 3.
Troubleshooting NOTE: To maintaine the performance of the shower panel. It is recommended to clean the thermostatic valve at least once a year. More frequent cleaning is needed if water has high mineral content. NOTE: Proper pressure must be maintained for the thermostatic valve to work properly. Make sure water pressue is about the same on both hot and cold water side. 1.
Cleaning The Thermostatic Valve Before You Begin • Read and understand this instruction completely before service the shower panel. • Make sure the water supply is shut off to the unit. If necessary, shut off the water to the entire house. • Turn on one of the faucets in the house to relieve the water pressure in the plumbing system. • Make sure the service site is clean and free of dust and debris. Parts Diagram Fig. C Fig. D 9 7 6 Fig. A 5 4 100 .4 3-1 3 Fig. E 8 2 Fig. B 1 1. Cap 2.
Calibrating The Thermostatic Valve Before You Begin • Read and understand this instruction completely before service the shower panel. • Make sure the service site is clean and free of dust and debris. The valve may needs to be recalibrated after the valve was replaced or cleaned. The thermostatic valve is preset at 100.4 degree Fahrenheit when the safety pin is pointing at 12 o’clock position (Figure F) This is the starting point of the calibration.
Appendix A. This diagram provides a general idea of the outlet box. Actual installation may vary. Consult a professional if necessary. You may also refer to the following link for a video demonstration of the general installation process. NOTE: Luxier is not affiliated with the owner of the video. The purpose of this video is meant to provide a visual concept of the shower outlet box to speed up the installation process. All images are copyright to their respective owners. https://youtu.
