Operation Manual

37
Controlling other Components Connected to the DVA-250
Learning a Pre-programming Code
By following one of the methods below, you may program the remote
to operate a wide range of devices from other manufacturers.
Direct Code Entry Method
Find the 3-digit number for the brand name of the component that
you want to operate in the code list following pages. (See 38 page.)
Turn on the component that you want to operate.
While holding down the DEVICE button on the remote controller
that you want to program, press the ENTER button for 2 seconds,
and then release both buttons.
Then the indicator blinks twice.
Within 10 seconds, enter the 3-digit code number.
(Correct input: Indicator blinks fourth.
Incorrect input: Indicator blinks once.)
If the component does not operate properly, return to step and
repeat the steps above.
Manual Search Method
Turn on the unit that you wish to include in the DVA-250 remote
controller.
Press the DEVICE button (VCR, SAT, TV) and the ENTER button at
the same time for 2 seconds until the indicator blinks twice.
Press the
5 or b button. Each press will send out a series of
codes from the remote's built-in database.
When the unit being programed turns off, press the ENTER button.
(Correct input: Indicator blinks fourth.
Incorrect input: Indicator blinks once.)
Code Check Method
Check if enter the 3-digit code number directly.
While holding down the DEVICE button, press the ENTER button for
2 seconds and then release both buttons and then the indicator blinks
twice.
Press the DIGITAL button.
The 3-digit code number blinks in order.
Example: If you enter '105'
1. 1: Indicator blinks once.
2. 0: Indicator blinks tenth.
3. 5: Indicator blinks fifth.
3
2
1
C
4
3
2
1
B
35
4
3
2
1
A
ENTER
DIGITAL
INDICATOR
Numeric
DEVICE
The DVA-250 is equipped with a powerful remote control not only
DVD's functions, but also most popular brands of audio and video
equipment, including CD players, cassette decks, TV sets, cable
boxes, VCRs, satellite receivers and other home theater equipment.