Specifications

ManualsBrandsLuxmann ManualsElectrical EquipmentMicrowave sensor ceiling lamp

Microware induction Ceiling Light



Model CK-W06A-001



SPECIFICATIONS



Range ................................................................Up to 24 ft. (8 m)

Sensing Radius....................................................Up to 3m

Electrical load - integrated LED .......................13Watts

Lumens ..............................................................700lm Power

Requirements ..........................................100-240VAC



Summary of content (5 pages)

PAGE 1
Microware induction Ceiling Light Model CK-W06A-001 SPECIFICATIONS Range ................................................................Up to 24 ft. (8 m) Sensing Radius....................................................Up to 3m Electrical load - integrated LED .......................13Watts Lumens ..............................................................700lm Power Requirements ..........................................
PAGE 2
DISASSEMBLE LIGHT FIXTURE SAFETY INFORMATION 1. 2. Remove cover from base. Please read and understand this entire manual before attempting to assemble, operate, or install the product. is light xture require 100-240VAC.All wiring must be in accordance with the National Electrical Code (Canadian Electrical Code in Canada). Some local electrical codes WARNING • CAUTION • Do not cut any wires that have factory installed wire connectors or remove the wire connectors.
PAGE 3
WIRING THE LIGHT FIXTURE Note: All wiring must be run in accordance with the Na- Black tional Electrical Code through conduit or another accept- Light able means. question as to the suitability of the system. Green or Bare Copper Twist the wires together and secure with wire connectors. 1. Route the junction box ground wire through the large White hole next to the ground screw (GND). Attach the ground wire under the ground screw. 2. Using the wire connectors: • Connect all white wires together.
PAGE 4
MOUNTING THE LIGHT FIXTURE 1. Make sure wire connectors and wires are inside the junction box. 2. Slide the xture base onto the mounting screw 3. Tighten the mounting screws securely against the light Junction Box Mounting Screw 4. use the two decorative nut to install the light xture cover.
PAGE 5
FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.