Stand Instructions
Table of Contents Table of Contents and Warnings 2 Part List 3 Assembly and Installation 1. Adjust upper and lower poles 4 2. Attaching to the base assembly 5 3. Installing the Media Shelf 6 4. Install steel cross rods 7 5. Install the TV 8 6. Install mount to frame 9 7. Adjusting the mount 10 Tools Required Phillips Screwdriver Tape Measure Wrench Assistance Required WARNING! Severe personal injury and property damage can result from improper installation.
A1x1 B2x2 A2x4 A3x1 C1x1 C2x1 C3x1 B3x1 D1x1 D2x2 D3x2 B4x4 B1x1 E D 8 25 G H 4 0 5 8 5 I J 16 K 10 L 4
1 1 Adjust upper and lower poles Locate the spring plungers inside the bottom grommet hole of pole B1 (If your unit has B3 cross bar pre-installed remove prior). Starting with the right side poleB2, push the spring plunger down and pull B2 up slightly and twist it slightly so that the spring plunger remains 2 Hold the poles B1 & B2 with your hands and use your left foot on the cross bridge of B1 for stability. Pull B2 upward until you reach your desired height.
2 Attaching to the base assembly 1 Thread casters A2 into the bottom of base A1. Make sure all casters a re locked to prevent movement during installation . 2 With allen wrenchM attach lower poles B1 to base A1 with screw G. First through the bottom of baseA1, then through the top of baseA. 3 A3 After screws G until it locks into place.
3 Install the media shelf Remove Pre-Installed Screws 1 C2 Pre-Installed 2 1 3 2 Pre-Installed C1 C3 1 Pre-Installed 2 L
4 Install steel cross rods B3 B3 B3 1 2 B2 B3 Phillips screwdriver 3 Remove the pre-installed screws on rod B3. Making sure the upper poles B2 are aligned, slide rods B3 into the top openings. Refasten rods B3 with screws. Assistance Required Cables Unplugged H / 1050mm - 1500mm 4a Height adjustment B4 B4 B4 B4 Slide the upper poles B2 up or down to the different spring plunger holes for your desired height. Install grommet covers B4 into the grommet holes.
5 Install the TV Remove pre-installed screws D3 5a D1 D2 Slider plate J D K (B, C)+D,A E D 5b VESA: 200x200mm D E B, C Phillips screwdriver Spacer Suggestions
6 Install mount to frame 1 2 Lift up lock hook before installing mount D1 Make sure casters are locked prior to installation 3 4 Secure lock hook fully Heavy Lifting: Assistance Required Attach hooks on D1 onto cross rods B3 D1 B3 I Lock not included
7 Adjusting the mount Remove pre-installed screws Re-attach screws D1 D1 Phillips screwdriver Phillips screwdriver Swivel 90°
