Installation Guide

06/22/15
A x4 B x1 C D
7.875˝ (200mm)
18.125˝ (460mm)
A
A
A
B
A
7.875˝ (200mm)
18.125˝ (460mm)
C
D
Attachment
Requires Two
People
1. Place the unit in the desired location.
2. Using a pencil, mark the front two holes.
3. Using a pencil, mark the back two holes through the
side grommet holes.
4. Remove the unit, and conrm marks are in the correct location
(18.125 left to right, and 7.875 front to back).
5. Mark a center point between the back two holes.
6. Drill 5 holes using the 1/8” drill bit.
7. Return the unit, and secure in place with screws (A and B).
Assistance required on all steps
1. Place the unit in the desired location.
2. Level the unit, and hold in place.
3. Mark the top 2 holes with a pencil.
4. Mark the bottom 2 holes with a pencil through the grommet holes.
5. Remove the unit, and conrm holes are in the correct location
(18.125 left to right, and 7.875 top to bottom).
6. If mounting to drywall, drill holes with the 1/4” drill bit, and place
anchors (C) in the holes
7. If mounting to a stud, drill holes with 1/8” drill bit
8. Return the unit to the location, and secure in place with screws (D).
Surface / Wall Device
Charging Station Guide
WARNING: Two people are required to
attach this charging station to a wall.
Surface Mount Wall Mount
Parts List
- Tape Measure
- Level
- Drill
- 1/4˝ Drill Bit (No Stud)
- 1/8˝ Drill Bit (Stud)
- Extended Drive Phillips
- Level
- Stud Finder
- Pencil
Tools Required
Note: Hardware provided is for drywall installation. If attaching
to other material fasteners are to be furnished by other.
M5x18 M5x40 Plastic Anchor M5x25
STUD
NO STUD
DRYWALL
RECOMMENDED:
DRYWALL
1/8˝ Bit
1/4˝ Bit
C