User Manual

ManualsBrandsLuxor ManualsRoom DividersRECLAIM Acoustic Room Dividers - Single Panel in Misty Gray

Box 1 Box 2

LuxorFurn.com/Reclaim

Parts:

Stand Alone or Extender Installation

Flat Feet x2

(Stand Alone)

Flat Foot x1

Peg Foot x1

(Extender)

Room Divider Panel x1

Please read all instructions before installation. Start by laying the Room Divider Panel on a large, at,

stable surface. Find the pre-drilled holes in the bottom of the divider. Take the set of feet that came with

the product and slide them in until the round disk on the foot is up against the Divider Panel.

* Please note: The foot type included in box 2 depends on SKU ordered.

Instructions for the RECLAIM™ Room Divider Panels

Summary of content (5 pages)

PAGE 1
Instructions for the RECLAIM™ Room Divider Panels Stand Alone or Extender Installation Parts: Box 1 Box 2 Flat Feet x2 Room Divider Panel x1 (Stand Alone) Flat Foot x1 Peg Foot x1 (Extender) * Please note: The foot type included in box 2 depends on SKU ordered. 1 Please read all instructions before installation. Start by laying the Room Divider Panel on a large, flat, stable surface. Find the pre-drilled holes in the bottom of the divider.
PAGE 2
Very carefully rotate Divider Panel off of flat surface into a standing position on the floor. For best results, make sure feet are flat and even against the floor. Or LuxorFurn.
PAGE 3
-Panel or Multiple Set Installation Parts: Box 1 Box 2 Flat Foot x3 Peg Foot x3 Room Divider Panel x3 1 Start by laying the Room Divider Panels on a large, flat, stable surface. Please note that the Panel with zippers on both sides goes in the middle and the outside Panels should have the zippers facing inwards towards the middle Panel. Find the pre-drilled holes in the bottom of the dividers and make sure they are all on the same side of the table.
PAGE 4
2 Once the Panels are zipped together, gather the sets of feet for the Panels. Slide the feet in until the round disk on the foot is up against the Divider Panel. Please note the foot placement shown below. The Flat feet need to go on the outside of the end Panels for optimal stability. LuxorFurn.
PAGE 5
2 With help, very carefully rotate Divider Panel off of flat surface into a standing position on the floor. For best results, make sure feet are flat and even against the floor. Assistance Recommended LuxorFurn.