Instructions / Assembly

3 / 16
IMPORTANT SAFETY
INSTRUCTIONS
Read all instructions before
using the product.
Every person who is responsible for
this table at installation or employment
of the table in daily use or in service
and repair work should carefully
read these instructions. Keep these
instructions close to your sit/stand
table.
DANGER
To reduce the risk of electric shock:
Always unplug this furnishing from the
electrical outlet before cleaning.
WARNING
To reduce the risk of burns, re,
electric shock, or injury to persons:
1. Unplug from outlet before putting
on or taking o parts.
2. Use this furnishing only for its
intended use as described in
these instructions. DO NOT use
attachments not recommended by
the manufacturer.
3. DO NOT operate this furnishing
if it has a damaged cord or plug,
if it is not working properly, if it
has been dropped or damaged,
or dropped into water. Return the
furnishing to a service center for
examination and repair.
4. Keep the cord away from heated
surfaces.
5. DO NOT use outdoors.
6. DO NOT operate where aerosol
(spray) products are being
used or where oxygen is being
administered.
7. DO NOT overload the table -
maximum load is 70kg / 154 lbs.
8. Close supervision is necessary
when this furnishing is used by, or
near children, invalids, or disabled
persons.
This appliance shall only be used
together with the included power
supply unit. If you are having trouble
with your power supply or your power
supply is not operating correctly, DO
NOT disassemble contact your local
dealer.
Usage of the Table
• The table shall only be used as a
working table with the possibility
to continuously adjust working
height between sitting and
standing position. The table shall
only be used indoors and in dry
premises (oce environment or
similar).
• The table must not be overloaded
- maximum load is 70 kg / 154
lbs. The motors may be run
continuously for a maximum
of one (1) minute. Afterward,
the motors must stand by for
approximately nine (9) minutes
before they can be used again.
• The motors stop automatically
when the table reaches its lowest
or highest position respectively.
• If the unit has been unplugged or
a power outage occurs a system
reset will need to be performed.
To reset the system simply hold
the right (lowering) button until the
desk reaches it’s lowest position
then wait for (5) seconds for the
gears to reset.
• ATTENTION! The electrical cable
must have full mobility. Place the
cables so that they DO NOT get
tangled or damaged.
1.
2.
3.
4.
5.
6.
8.
7.