Instructions / Assembly

installation instructions:

LuxorWareWallPanels

SAFETY INSTRUCTIONS

Make sure to use the correct tools recommended.

Wear proper protective gear.

Follow fixture, power tools, paint manufacturers’ instructions, and users’ manuals.

Use common sense and follow good construction practices.

TOOL & MATERIAL CHECKLIST

SPECIAL INSTRUCTIONS AND

NOTES

Contact Adhesive

Utility Knife, Circular Saw, or Table Saw

Paint Brush or Roller

Measuring Tape

Sand Paper

Sheetrock Compound (Optional, see instructions.)

Putty Knife (Optional, see instructions.)

• Thoroughly read through the install instructions to familiarize yourself with the process before

beginning installation.

• Before installing, acclimate the panels in the room where you will be installing them.

• In most applications you will have to trim some panels. Cut them with a standard utility knife

or power tool, such as a table saw. Sand cut edge to remove debris.

• Depending on your installation, you will have to choose the correct adhesive.

STEP BY STEP INSTRUCTIONS

EXAMPLE

INSTALLATION DIAGRAMS

PAGE 1
installation instructions: LuxorWareWallPanels SAFETY INSTRUCTIONS Make sure to use the correct tools recommended. Wear proper protective gear. Follow fixture, power tools, paint manufacturers’ instructions, and users’ manuals. Use common sense and follow good construction practices. TOOL & MATERIAL CHECKLIST SPECIAL INSTRUCTIONS AND NOTES • Contact Adhesive Thoroughly read through the install instructions to familiarize yourself with the process before beginning installation.
PAGE 2
1. Prepare installation surface with sandpaper by removing excessive bumps or texture. Wipe clean and apply primer to ensure proper adhesion. 2. Mark the installation points using a straight edge and level. a. On a wall with one corner start at the end wall and work towards the corner (Diagram A) b. For a wall with two corners start at the center and work out (Diagram B) 3. Apply adhesive to the back of the panel and the installation area.