Instructions / Assembly

1. Prepare installation surface with sandpaper by
removing excessive bumps or texture. Wipe clean
and apply primer to ensure proper adhesion.
2. Mark the installation points using a straight edge and
level.
a. On a wall with one corner start at the end wall and
work towards the corner (Diagram A)
b. For a wall with two corners start at the center and
work out (Diagram B)
3. Apply adhesive to the back of the panel and the
installation area. (Follow adhesive manufacturer’s
instructions for proper application)
a. Install panels side by side. (These panels are
designed to minimize the appearance of seams.)
(Diagram C)
b. For a seamless appearance, leave a 1/16-inch gap
between each panel. After the panels have dried,
apply a layer of primer over the surface. Once the
primer has dried, go over the seams with sheetrock
compound. This may take two or more applications.
Be sure to sand between each application.
(Diagram D)
4. Once installed, you can leave the product with its’
white factory finish, or prime and paint any desired
color.
Diagram C
Diagram D