User Manual

USER MANUAL
Operation Instructions
Constructed with aircraft-grade aluminum
Push/pull focus beam
Enhanced rubber grip
High quality wrist lanyard
Tactical on/off button
IPX4 waterproof rating
Batteries included (3 AAA)
Features
14725 S Porter Rockwell Blvd Ste C
Bluffdale, UT 84065
luxpro.com
866.553.8886
The LP830 has a Limited 30-Day Warranty Against Manufacturer’s
Defects from time of purchase.
For warranty claims please contact us by calling 801-553-8886 or
sending an email to [e-mail]
Product Warranty
Low
High
ANSI/PLATO FL1 STANDARD
50 lm
120 lm
LUMENSMODES
8h
5h
RUN TIME
25m
50m
BEAM
DISTANCE
Strobe 120 lm -- --
Focusing Universal Flashlight
LP830
3
AAA
Batteries
Cycle Modes: First turn the light on by pressing down the button
on the tail cap completely and releasing. Half-press the button to
cycle through modes (High/Low/Strobe). Turning the flashlight on
and off quickly and repeatedly will also cycle the light through the
three modes.
The light will automatically reset to
high mode when off for longer than
5 seconds.
Focus Head: To focus the light beam,
gently push the head away from the
light to extend it. Pull the head back
towards the light to widen the beam.
On/Off: Press and release the button on the tail cap to turn the
light on and off.
Battery Replacement
The LP830C uses 3 AAA batteries.
To replace the batteries, turn the tail cap counterclockwise to
remove it. Tip the light downward to slide out the battery case
which contains the batteries. Remove the batteries from the case
and insert new batteries according to the (+/-) symbols found on
the case. For best results, we recommend using brand new
alkaline batteries that are the same voltage and brand.
Re-insert battery case into the flashlight with the arrow on the
battery case pointing down. Re-attach the tail cap by pressing
down lightly and turning it clockwise until tight.
If you know it will be a while between uses, we suggest removing
the batteries from the flashlight and storing it in a dry, protected
place.